Kustom none manual 8BOOST INDICATOR When lit, this indicates that the Boost func- tion is active

Page 10

8)BOOST INDICATOR When lit, this indicates that the Boost func- tion is active.

5

4

8)BOOST INDICATOR When lit, this indicates that the Boost func- tion is active.

9)BOOST CONTROL This adjusts the amount of footswitchable boost and is particularly useful for solos. It provides up to 10dB of “Master Volume” boost, regardless of which channel is active.

The boost is active if the footswitch is unplugged. The Boost oc- curs after the effects loop, so no adjustment of your effects will be neccessary.

10)MASTER This is a global master volume control which sets the overall loudness of the entire amplifier. The Master is also after the effects loop.

1

32

11)JEWELED PILOT LIGHT Indicates that the amplifier’s power switch is in the “On” position.

12)STANDBY This allows the amplifier to be powered up, but with

the tubes in a non-operational mode. The Standby can be used in- stead of the power switch between performance sets, since it allows the amp to “shut down” while keeping the tubes warm and ready to go. It’s also best to power the amp up with this switch set to the left/off position until the tubes have had a few minutes to warm up, although modern tubes are more tolerant of this.

13)POWER Provides AC power to the amplifier when in the “On” position—switched to the right.

9

Image 10

Contents Page Table of Contents FCC Statements Page S a f e t y I n f o r m a t i o n S a f e t y I n f o r m a t i o n S a f e t y I n f o r m a t i o n S a f e t y I n f o r m a t i o n Front Control Panel 8BOOST INDICATOR When lit, this indicates that the Boost func- tion is active Rhythm Channel Rhythm Channel Settings American Clean Classic Chime Black AngusLead I Channel Lead I Channel Settings Thick Modern Cranked Vintage Heavy DynamicLead II Channel Lead II Channel Settings Tight Aggression Fluid Legato Unleashed MonsterBright + Tight BrightBright + Gain THE CROSSTight + Thick 4 Bright + Thick5 Bright + Thick + Tight Bright + Gain +Rear Control Panel Vintage 30-loaded Straight-front4x12 speaker cabinet. When the switch is OUT, it emulates the same speakers in a Slant- front 412 cabinet. Kustom went to great lengths to make sure that this signal sounded like the actual amp head and speaker cabinet combinations. This was accomplished in a studio envi- ronment using condenser microphones to analyze the tonality of the Double Cross when heard at “head level” versus “close mic’d” directly in front of the speaker. The result is a signal that reflects the true characteristics of these cabinets as heard by a player. If you haven’t tried the Double Cross’ Direct Out yet, we urge you to experiment with it for both live and studio ap- plications 0 dBV 1v Rack Effects Optimal 10dBV 0.3v Pedal Effects OptimalEffects Loop Syncing System Gain Amp SpecificationsNominal Signal to Noise Effects LoopSignal Flow Diagram