Kustom none manual Amp Specifications, System Gain, Nominal Signal to Noise, Effects Loop

Amp Specifications

	Model	Double Cross	All Tube 3 channel guitar amp head
	Tubes	Power Amp Tubes	6-6L6GC or EL34 power tubes using AUTOKRUISE TM biasing scheme
		Preamp Tubes	5-12AX7 preamp tubes & 1-12AT7 buffer tube for power amp
	Output Power	100 W RMS	16, 8, or 4 Ohms @ 5% THD using 6L6s, 110W w/EL34s
	Input Impedance	1M ohms Normal or Tigh	t Inputs
	System Gain	50 dB	Rhythm Channel Nominal gain, Normal Input, Gain @ 5
	All measurements taken with 1 KHz	64 dB	Rhythm Channel Maximum gain, Normal Input, Gain @ 10
		10 dB	Rhythm Channel extra gain when Drive is activated
	input signal, Tone controls flat, Gain
		+3 dB	Gain increase at 1 kHz when Bright is activated
	Halfway and Volume Maximum, Boost
		90 dB	Lead I or II Channels Maximum gain, Normal Input, Gain @ 10
	@ 10, Effects OFF, overall Master @
		75 dB	Lead I or II Channels Nominal gain, Normal Input, Gain @ 5
	10. All Bright, Drive & cross switches
		8 dB	Broadband gain increase with only Lead Gain switch activated
	off. Measured at speaker jack at 16
		5 dB	Gain increase with only either Tight or Thick stage activated
	ohms unless noted.
		10 dB	Gain increase with all switches engaged
	Nominal Signal to Noise	64 dB	Rhythm Channel, with Volume half and Master Maximum, Boost on 10
		0.15 VRMS (-16 dBV)	Levels w/Boost, Send & Master @ 10 to reach full power output
	Effects Loop	0.45 VRMS (-6 dBV)	Levels w/Boost & Master @ 10, but with Send @ 0 to reach full power
		Effects Send	Tube driven, Nominal load >10k ohms
		Effects Return	Tube driven, >100K ohm input impedance
	Footswitchable Boost	Master Volume Boost	Adjustable from 0 to +10 dB boost AFTER the Effects Loop
	XLR Direct Output		After power amp w/speaker emulation of 412 Straight & Slant cabs
		Output level	Adjustable from 0 to +6 dBV, nominal -3 dBV
	Footswitch	Supplied Footswitch selects Rhythm, Lead I or Lead II Channel, Boost, and Effects Loop On/Off
		Uses a standard stereo shielded cable, and should be plugged in before turning on amp
		USA/Canada	120VAC/60Hz, 450W nominal
	Power Requirements	Europe/UK	230VAC/50Hz, 450W nominal
		Australia	240VAC/50Hz, 450W nominal
		Japan	100VAC/50-60Hz, 450W nominal
	Dimensions/Weight	mm/kg	304 mm (Height) x 686 mm(Width) x 276 mm(Depth), 21.3kg
22		Inches/Pounds	12" (Height) x 27" (Width) x 10.875" (Depth), 47 lbs