Toshiba SD-M1201 installation instructions Completing Installation, DVD-ROM Front Panel

Page 6
2.5 - 3.5mm
Mounting frame of host computer
Surface of side or bottom of DVD-ROM drive
M3
Mounting Screw

COMPLETING INSTALLATION

After you have connected all the necessary cables, push the DVD-ROM completely into the computer’s drive slot. Mount drive accord- ing to your computer’s instruc-

tions. The screw length should not exceed 3±0.5mm (measured from outside surface of side or bottom of DVD-ROM to tip of screw). Replace computer cover and all outer screws.

Software Driver: The Toshiba SD-M1202 DVD-ROM Drive is “plug n’ play.” When you apply power to your computer and boot-up, it should recognize the new hardware and prompt you in the installation of the SCSI driver. If you don’t have the SCSI driver, contact your SCSI host adapter board manufacturer. After you have completed installing your DVD-ROM, refer to REALmagic™ User’s Guide to install DVD/MPEG-2 Playback Card.

DVD-ROM FRONT PANEL

The photo illustrates the following features of the SD-M1202 DVD-ROM front panel:

DVD loading tray

Headphone jack

Volume control

Busy light

Eject button

Emergency eject hole (insert solid bar into hole, i.e. paper clip, and push until tray opens)

6

Image 6
Contents Checking Your KIT Packaging System RequirementSetting Jumpers Connecting Cables Placing DVD-ROM Inside Your ComputerPage SD-M1201 Connection ONE Drive Completing Installation DVD-ROM Front PanelDVD-ROM Back Panel SD-M1201 Specifications DVD CD-ROM Technical Support