AMX manual Installing the NXD-500i panel within a Rough-In Box, C - Optional CB-TP5i

Installation

5.Install the drywall/sheetrock before inserting the main NXD-500i device into the CB-TP5i.

Installing the NXD-500i panel within a Rough-In Box

The Rough-In Box must be mounted prior to continuing this section. Refer to the procedures in the Pre-Wall Installation of the Rough-In Box section on page 9 for detailed pre-wall installation instructions. Verify that all necessary cables have been threaded through the knockouts on the left of the Rough-In Box and the connections have been tested prior to installation of the NXD-500i.

1.Remove the Faceplate bezel (A in FIG. 6) from the main NXD-500i unit (B in FIG. 6) by gripping the faceplate from the top and lifting up and then pulling with gentle outward force.

C - Optional CB-TP5i	Stud
rough-in/wallbox

Locking Tab

Screws for mounting

Back Box to touch panel

B - Main NXD-500i unit consists of the touch panel and back box housing

A - Faceplate/Trim Ring

FIG. 6 NXD-500i panel installation into a CB-TP5i (pre-wall construction)

Be sure to pull the faceplate UP before pulling it out and away from the rest of the device. Pulling straight outward may lead to damage to the faceplate, including breaking off the tabs that attach the faceplate to the device.

2.Gently unscrew the two screws attaching the NXD-500i to its back box. These are at the bottom of the device, underneath the touch screen. Carefully remove the NXD-500i from the back box.

While the screws are loosened, you can adjust the LCD to ensure it is parallel to the sides of the backbox, if necessary. While adjusting the LCD is possible, it is not required in most cases.

3.Thread the incoming Ethernet and USB wiring from their terminal locations through the surface opening. Leave enough slack in the wiring to accommodate any re-positioning of the panel.

4.Push the back box into the wall opening. Insure that the locking tabs lie flush against the back box.

5.Extend the locking tabs on the sides of the back box by tightening the screws inside the box. Not all of the tabs must be extended to lock the back box in place, but extending a minimum of the top and bottom tabs is highly recommended. Apply enough pressure to the screw head to keep the box flush

10 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom