AMX NXD-500i manual Obtained from NetLinx Master, System Connection page

Configuring Communication

Before commencing, verify that the NetLinx Master is using the latest available version of its firmware.

2.Verify that the NetLinx Master is receiving power and is communicating via an Ethernet connection with the PC running NetLinx Studio.

3.Verify that the green Ethernet LED on the rear Ethernet port on the Master is illuminated, indicating a proper connection.

4.Verify that the yellow LED on the rear Ethernet port on the Master is blinking, indicating communication with the device.

5.After the panel powers-up, press and hold the Front Setup Access button for 3 seconds to proceed to the Setup page.

6.Select Protected Setup > System Connection (located on the lower-left) to open the System Connection page (FIG. 24).

Obtained

from

NetLinx

Master

FIG. 24 System Connection page

Master Connection section - Virtual Master communication over Ethernet

When configuring the panel to communicate with a Virtual Master (on your PC) via Ethernet, the Master IP/URL field must be configured to match the IP Address of the PC. Make sure to use the Virtual System value assigned to the Virtual Master within NetLinx Studio.

Before beginning:

1.Verify that the panel has been configured to communicate through an Ethernet cable connected from the panel to a valid Ethernet Hub.

2.Launch NetLinx Studio 2.x (default location is Start > Programs > AMX Control Disc > NetLinx Studio 2 > NetLinx Studio 2).

3.Select Settings > Master Communication Settings, from the Main menu to open the Master Communication Settings dialog (FIG. 25).

4.Click the Communications Settings button to open the Communications Settings dialog.

5.Click on the NetLinx Master radio button from the Platform Selection section to indicate that you are working as a NetLinx Master.

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom 33