AMX NXD-500i manual Flat installation surface

Installation

The USB connectors can be from either a USB extension cable or a wireless USB RF transmitter.

6.Test the incoming wiring by connecting the panel connections to their terminal locations. Verify that the panel is receiving power and functioning properly before finalizing the installation.

Flat installation surface

Install the three #4 Mounting Screws (not included) into these three holes (suggested length of screws is 0.25")

Attachment is done along the edges of the cutout

Locking Tab

B - Main NXD-500i unit

A - Faceplate/Trim Ring

FIG. 11 Wall Mount panel installation configuration for flat surfaces

Do not disconnect the connectors from the touch panel. The unit must be installed with the necessary connectors before being inserted into the solid surface.

7.Carefully slide the main unit into the cutout, making sure that the locking tabs lie flush against the back box.

8.Insert and secure three #4 Mounting Screws (not included) into the corresponding holes located along the sides of the NXD-500i, using a grounded Phillips-head screwdriver, until the unit is secure and flush against the wall (FIG. 11).

9.Place the Faceplate/Trim Ring assembly (A in FIG. 11) back onto the device (B in FIG. 11). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.

16 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom