AMX NXD-500i manual Table of Contents

Table of Contents
Table of Contents
Introduction	1
NXD-500i Specifications	3
Front Bezel Button	5
Ethernet and mini-USB Ports	5
Installation	7
Installing the Trim Ring	7
Removing the Faceplate	8
Installation of an NXD-500i Touch Panel	9
Pre-Wall Installation of the Rough-In Box	9
Installing the NXD-500i panel within a Rough-In Box	10
Installing the NXD-500i into drywall	12
Installing the NXD-500i into a Flat Surface using #4 screws	15
Installing an NXD-500i into a Rack Mount Kit (NXA-RK5)	17
Wiring Guidelines for the NXD-500i Panel	18
Ethernet/RJ-45 Port: Connections and Wiring	18
NXD-500i Touch Panel Accessories	19
PS-POE-AF PoE Injector	19
Panel Calibration	21
Calibrating the Modero Panel	21
Configuring Communication	23
Modero Setup and System Connection	23
Configuring and Using USB with a Virtual Master	25
Step 1: Setup the Panel and PC for USB Communication	25
Step 2: Confirm the Installation of the USB Driver on the PC	25
Step 3: Confirm and View the current AMX USB device connections	27
Step 4: Use the USB to Configure a Virtual Master (using NetLinx Studio)	28
Step 5: Confirm and View the current AMX USB device connections	29
Configuring a Wired Ethernet Connection	31
Step 1: Configure the Panel’s Wired IP Settings	31
IP Settings section - Configuring a DHCP Address over Ethernet	31
IP Settings section - Configuring a Static IP Address over Ethernet	31
Step 2: Choose a Master Connection Mode Setting	32
Step 3: Configure an Ethernet Connection Type	32
Master Connection section - Virtual Master communication over Ethernet	33
Master Connection section - NetLinx Master Ethernet IP Address - URL Mode	35
Master Connection section - NetLinx Master Ethernet IP Address - Listen Mode	36

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom i