AMX NXD-500i manual Using G4 Web Control to Interact with a G4 Panel, G4 Web Control page

Configuring Communication

The NetLinx Master and the Modero panel must both be on the same Subnet.

Using G4 Web Control to Interact with a G4 Panel

The G4 Web Control feature allows a PC to interact with a G4-enabled panel via the web. This feature works in tandem with the new browser-capable NetLinx Security firmware update (build 300 or higher). G4 Web Control is only available with the latest Modero panel firmware.

Refer to the G4 Web Control Page section on page 62 for more detailed information on G4 Web control.

Verify that the NetLinx Master (ME260/64 or NI-Series) has been installed with the latest firmware KIT file from www.amx.com. Refer to the NetLinx Master instruction manual for more detailed information on the use of the new web-based NetLinx Security.

1.Press the Front Setup Access button for 3 seconds to open the Setup page.

2.Press the Protected Setup button located on the lower-left of the panel page to open the Protected Setup page and display an on-screen keypad.

3.Enter 1988 into the Keypad’s password field (1988 is the default password) and press Done when finished.

Clearing Password #5, from the initial Password Setup page, removes the need to enter the default password before accessing the Protected Setup page.

4.Press the G4 WebControl button to open the G4 Web Control page (FIG. 27).

FIG. 27 G4 Web Control page

5.Press the Enable/Enabled button until it toggles to Enabled (light blue color).

6.The Network Interface Select field is read-only and displays the method of communication to the web. Verify the selection of the proper interface connection, as this field does not auto-detect the connection type being used (see below).

Wired is used when a direct Ethernet connection is being used for communication to the web. This is the default setting if no wireless interface card is detected or if both an Ethernet and wireless card connection is detected by the panel.

Wireless is used when a wireless card is detected within the internal card slot. The NXD-500i panel does not provide wireless communication, so this option is not available.

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom 37