AMX NXD-500i manual Intercom Commands, Programming, Model?

Programming

Intercom Commands

The following is a list of Intercom Commands:

Intercom Commands

^MODEL?	Panel model name. If the panel supports intercom hardware it will respond with its model
Sets model name.	name as shown in the response below. Older hardware or newer hardware that has inter-
	com support disabled with not respond to this command.
	Syntax:
	SEND_COMMAND <DEV>,"'^MODEL?'"
	Variables:
	None.
	Example:
	SEND_COMMAND TP1,"'^MODEL?'"
	Panel response string if intercom enabled:
	^MODEL-MVP-8400i
^ICM	For backwards compatibility, both ^ICM-TALK and ^ICM-LISTEN are supported. In this
Modifies an	release, however, the TALK and LISTEN subcommands are ignored. The microphone
	and/or speaker are activated based on the initial mode value of the intercom start
intercom call.
	command and the audio data packet flow is started upon receipt of this command by the
	panel.
	Syntax:
	SEND_COMMAND <DEV>,"`^ICM-TALK`"
	Variables:
	None.
	Example:
	SEND_COMMAND TP1,"`^ICM-TALK`"
^ICS-	^ICS-<IP>,<TX UDP port>,<RX UDP port>,<initial mode>'"
Intercom start.	Intercom start. Starts a call to the specified IP address and ports. The initial mode is either
	1 (talk) or 0 (listen) or 2 (both). Please note, however, that no data packets will actually
	flow until the intercom modify command is sent to the panel.
	Syntax:
	SEND_COMMAND <DEV>,"'^ICS-<IP>,<TX UDP port>,<RX UDP
	port>,<initial mode>'"
	Variables:
	IP = IP Address of panel to connect with on an Intercom call.
	TX UDP port = UDP port to transmit to.
	RX UDP port = UDP port to receive from.
	initial mode = 0 (listen) or 1 (talk) or 2 (handsfree). 0 is the default.
	Examples:
	Example of setting up a handsfree Unicast call between two panels:
	SEND_COMMAND TP1,"'^ICS-192.168.0.3,9000,9002,2'"
	SEND_COMMAND TP2,"'^ICS-192.168.0.4,9002,9000,2'"
	Example of setting up a multicast call where the first panel is paging two other panels:
	SEND_COMMAND TP1, "^ICS-239.252.1.1,9000,0,1"
	SEND_COMMAND TP2, "^ICS-239.252.1.1,9000,0,0"
	SEND_COMMAND TP3, "^ICS-239.252.1.1,9000,0,0"
	Example of setting up a baby monitor call where the first panel is listening to the
	microphone audio coming from the second panel:
	SEND_COMMAND TP1,"'^ICS-192.168.0.3,9000,9002,0'"
	SEND_COMMAND TP2,"'^ICS-192.168.0.4,9002,9000,1'"

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom 127