Configuring Communication

FIG. 30 Web Control VNC installation and Password entry screens

The G4 Web Control application is sent by the panel to the computer that is used for communication. Once the application is installed, this popup will no longer appear. This popup will only appear if connecting to the target panel using a different computer.

8.In some cases, a Connection Details dialog (FIG. 31) may appear that requests a VNC Server IP Address. This is the IP Address of the target touch panel, not the IP of the Master. Depending on the method of communication being used, it can be found in either the:

Wired Ethernet - System Connection > IP Settings section within the IP Address field.

Wireless - Not available with the NXD-500i panel.

If this field does not appear, continue to step 9.

IP Address of touch panel

- obtained from IP Settings section of the System Connection page

FIG. 31 Connection Details dialog

9.If a WebControl password was set up on the G4 WebControl page, a G4 Authentication Session password dialog box appears on the screen within the secondary browser window.

10.Enter the Web Control session password into the Session Password field (FIG. 30). This password was previously entered into the Web Control Password field within the G4 Web Control page on the panel.

11.Click OK to send the password to the panel and begin the session. A confirmation message appears stating "Please wait, Initial screen loading.".

40

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom

Page 46
Image 46
AMX manual Wireless Not available with the NXD-500i panel, If this field does not appear, continue to step