AMX NXD-500i Button Commands Cont, Programming, Set the button to, display either a, Video or

Programming

"^" Button Commands (Cont.)

^BOS	Syntax:
Set the button to	"'^BOS-<vt addr range>,<button states range>,<video state>'"
display either a	Variable:
Video or
	variable text address range = 1 - 4000.
Non-Video
window.	button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	video state = Video Off = 0 and Video On = 1.
	Example:
	SEND_COMMAND Panel,"'^BOS-500,1,1'"
	Sets the button to display video.
^BPP	Zero clears the flag.
Set or clear the	Syntax:
protected page flip	"'^BPP-<vt addr range>,<protected page flip flag value>'"
flag of a
	Variable:
button.
	variable text address range = 1 - 4000.
	protected page flip flag value range = 0 - 4 (0 clears the flag).
	Example:
	SEND_COMMAND Panel,"'^BPP-500,1'"
	Sets the button to protected page flip flag 1 (sets it to password 1).
^BRD	Only if the specified border is not the same as the current border. The border names are
Set the border of	available through the TPDesign4 border-name drop-down list.
a button state/	Syntax:
states.	"'^BRD-<vt addr range>,<button states range>,<border name>'"
	Variable:
	variable text address range = 1 - 4000.
	button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	border name = Refer toBorder Styles and Programming Numbers table on page 86.
	Example:
	SEND_COMMAND Panel,"'^BRD-500.504&510.515,1&2,Quad Line'"
	Sets the border by name (Quad Line) to those buttons with the variable text range of
	500-504 & 510-515.
	Refer to theTPD4 Border Styles by Name table on page 86.
^BSF	Note: Select one button at a time (single variable text address). Do not assign a variable
Set the focus to	text address range to set focus to multiple buttons. Only one variable text address can be
	in focus at a time.
the text area.
	Syntax:
	"'^BSF-<vt addr range>,<selection value>'"
	Variable:
	variable text address range = 1 - 4000.
	selection value = Unselect = 0 and select = 1.
	Example:
	SEND_COMMAND Panel,"'^BSF-500,1'"
	Sets the focus to the text area of the button.

98 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom