AMX manual NXD-500i Wall Mount panel dimensions

Installation

FIG. 8 NXD-500i Wall Mount panel dimensions

Making sure that the actual cutout opening be slightly smaller than the provided dimensions is highly recommended. This action provides the installer with a margin for error if the opening needs to be expanded. Too little drywall removed is always better than too much.

3.Remove the Faceplate/bezel (A in FIG. 9) from the main NXD-500i device (B in FIG. 9) by gripping the faceplate and pulling up and then out with gentle outward force.

4.Thread the incoming Ethernet and USB wiring from their terminal locations through the surface opening. Leave enough slack in the wiring to accommodate any re-positioning of the panel.

5.Connect both connectors to their corresponding locations along the left side of the NXD-500i touch panel.

B

A

FIG. 9 Wall Mount panel (NXD-500i) installation view for drywall surfaces - top view

6.Test the incoming wiring by attaching the panel connections to their terminal locations and applying power via the PoE Injector. Verify that the panel is receiving power and functioning properly to prevent repetition of the installation.

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom 13