AMX NXD-500i manual Connection Status, Setup Page Elements, Setup Pages and Descriptions

Setup Pages and Descriptions

Setup Page

This page (FIG. 36) centers around basic Modero panel properties, such as the Connection Status of the panel, Display Timeout, Inactivity Page Flip Time, Inactivity page file, and the Panel Brightness.

Connection Status

Red Connection Status icon -

indicates no connection to a Master

Green Connection Status icon - indicates communication

to a Master

FIG. 36 Setup page

The elements of the Setup page are described below:

Setup Page Elements

Exit:	Returns to the Main touch panel page. In this case, the previous page is the
	default Main page.
Connection Status icon:	This visual display of the connection status allows the user to have a current
	update of the panel’s connection status regardless of what page is currently
	active.
	• A Lock only appears on the icon if the panel has established a connection
	with a currently secured target Master (requiring a username and password).
Connection Status:	Displays whether the panel is communicating externally, the encryption status
	of the communicating Master, what connection type is being used (Ethernet or
	USB), and of what System the panel is a part.
	This visual display of the connection status is also reflected at the upper-right of
	each firmware page. This allows the user to have a current visual update of the
	panel’s connection status regardless of what page is currently active.
	• When a connection is established, the message displayed is either:
	"Connected via Ethernet " or "Connected via USB ".
	• If no connection can be established by the Modero panel, it will continue to try
	and establish a connection while displaying: "Attempting via...".
	• The word "Encrypted" appears only when an encrypted connection is
	established with a target Master.
	• The panel must be rebooted before incorporating any panel communication
	changes and detecting any active Ethernet connections.
	The Ethernet connection is only detected after the panel is rebooted.
Display Timeout:	Sets the length of time the panel can remain idle before activating the sleep
	mode. When the device goes into sleep mode, the LCD is powered down.
	• Press the UP/DN buttons to increase/decrease the time until the panel times
	out. Range = 0 - 240 minutes.
	• Use this button to set the timeout value to zero and disable the sleep mode.

48 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom