Dell 4600 technical specifications Reinstall the existing hard drive into the computer

Page 19

NOTICE: Ground yourself by touching an unpainted metal surface on the back of the computer.

NOTICE: When you unpack the drive, do not set it on a hard surface, which may damage the drive. Instead, set the drive on a soft surface, such as a foam pad, that will sufficiently cushion it.

5.Unpack the additional hard drive.

6.Check the jumper setting on the back of the second drive.

Ensure that the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).

7.Install the additional hard drive:

a.Insert hard-drive securing screws.

b.Place the two bracket tabs into the drive slots inside the computer's front panel.

c.Swing the bracket forward so that it is flush with the computer's front panel.

d.Replace the bracket-securing screws.

8.Reinstall the existing hard drive into the computer.

NOTICE: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").

Image 19

Contents Abbreviations and Acronyms Diagnostic Lights Advanced TroubleshootingLight Pattern Problem Description Suggested Resolution System board Beep CodesCode Cause Message Possible Cause Corrective Action System MessagesReseat the memory modules Back to Contents Shutting Down Your Computer Before You BeginGetting Started Recommended ToolsRemove the computer cover Back to Contents Replacing the Computer Cover Removing the Computer Cover PCI Cards Removing and Installing PartsRemoving an AGP Card AGP CardReplace the computer cover Memory Installing an AGP CardDDR Memory Overview Memory Installation Guidelines Installing MemoryFront Panel Replacing the Front Panel Removing the Front PanelRemove the front panel DrivesRemoving the Front-Panel Insert Replacing a Hard DrivePage Remove the existing hard drive Adding or Replacing a Second Hard DriveReinstall the existing hard drive into the computer Release and remove the front panel Adding a Floppy DriveAdding a Second CD or DVD Drive Release and remove the front panel Removing the Microprocessor MicroprocessorPage Installing the Microprocessor Removing the Fan Assembly Fan AssemblyRemoving the System Board Replacing the Fan AssemblyRemove the microprocessor heat sink Remove the fan assembly System BoardInstalling the System Board Power SupplyRemoving the Power Supply Reinstall the fan assembly BatteryReplacing the Power Supply Battery OverviewReplacing the Battery Technical Specifications Audio Ports and ConnectorsPower VideoEnvironmental System Setup Screens System SetupEntering System Setup Viewing SettingsSystem Setup Options Bus Speed System Memory Channel ModeAGP Aperture CPU Information CPU SpeedBoot Sequence Enter system setup Clearing Forgotten PasswordsRemove the computer cover Inside View of Your Computer System Board Components Technical OverviewOutput Voltage Minimum Current a Maximum Current A1 Power Supply DC Connector Pin AssignmentsPin Number Signal Name 18-AWG Wire DC Power Connector P1DC Power Connector P2 Pin Number Signal name AWG WirePin Number Signal Name 22-AWG Wire DC Power Connectors P3, P5, P6, P8 and P9DC Power Connector P4 DC Power Connector P7Back to Contents