Dell 4600 technical specifications Release and remove the front panel

Page 22

NOTE: Drives sold by Dell come with their own operating software and documentation. After you install a drive, see the documentation that came with the drive for instructions on installing and using the drive software.

2.Release and remove the front panel.

3.Pull the two front-panel tabs towards you, and then push out the front-panel insert.

4.Ensure that the jumper setting on the new drive is set for "cable select" (see the documentation that came with the drive for information).

5.Remove two extra alignment screws, shown in the following figure, from the front of the computer and insert them into the drive.

NOTE: Some computers come with only two extra alignment screws; others come with four. You only need two alignment screws for this procedure.

6.Gently slide the drive into place.

7.Once the drive is in place, apply pressure to ensure that the drive is fully seated.

8.Use the securing screw that came with the drive to attach the drive to the computer.

Image 22

Contents Abbreviations and Acronyms Diagnostic Lights Advanced TroubleshootingLight Pattern Problem Description Suggested Resolution System board Beep CodesCode Cause Message Possible Cause Corrective Action System MessagesReseat the memory modules Back to Contents Recommended Tools Before You BeginGetting Started Shutting Down Your ComputerRemove the computer cover Back to Contents Replacing the Computer Cover Removing the Computer Cover Removing and Installing Parts PCI CardsRemoving an AGP Card AGP CardReplace the computer cover Installing an AGP Card MemoryMemory Installation Guidelines Installing Memory DDR Memory OverviewFront Panel Removing the Front Panel Replacing the Front PanelReplacing a Hard Drive DrivesRemoving the Front-Panel Insert Remove the front panelPage Adding or Replacing a Second Hard Drive Remove the existing hard driveReinstall the existing hard drive into the computer Adding a Floppy Drive Release and remove the front panelAdding a Second CD or DVD Drive Release and remove the front panel Microprocessor Removing the MicroprocessorPage Installing the Microprocessor Fan Assembly Removing the Fan AssemblySystem Board Replacing the Fan AssemblyRemove the microprocessor heat sink Remove the fan assembly Removing the System BoardInstalling the System Board Power SupplyRemoving the Power Supply Battery Overview BatteryReplacing the Power Supply Reinstall the fan assemblyReplacing the Battery Technical Specifications Video Ports and ConnectorsPower AudioEnvironmental Viewing Settings System SetupEntering System Setup System Setup ScreensSystem Setup Options CPU Information CPU Speed System Memory Channel ModeAGP Aperture Bus SpeedBoot Sequence Clearing Forgotten Passwords Enter system setupRemove the computer cover Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments Output Voltage Minimum Current a Maximum Current A1Pin Number Signal name AWG Wire DC Power Connector P1DC Power Connector P2 Pin Number Signal Name 18-AWG WireDC Power Connector P7 DC Power Connectors P3, P5, P6, P8 and P9DC Power Connector P4 Pin Number Signal Name 22-AWG WireBack to Contents