Dell 4600 technical specifications Adding a Floppy Drive, Release and remove the front panel

Page 20

9.Connect the power and data cables to the back of the drives.

10.Replace the computer cover.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

11.Connect your computer and devices to electrical outlets, and turn them on.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

Adding a Floppy Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

1.Follow the procedures in "Before You Begin."

2.Release and remove the front panel.

3.Press in the two insert tabs, and then push out the front-panel insert.

4.Connect the floppy-drive power cable to the back of the drive.

NOTICE: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").

5.Connect the data cable to the back of the drive and to the floppy drive connector on the system board.

6.Position the top of the floppy drive bracket so that it is completely flush with the bottom of the upper drive bay, and then slide the floppy drive bracket

Image 20

Contents Abbreviations and Acronyms Light Pattern Problem Description Suggested Resolution Advanced TroubleshootingDiagnostic Lights Code Cause Beep CodesSystem board Reseat the memory modules System MessagesMessage Possible Cause Corrective Action Back to Contents Before You Begin Getting StartedRecommended Tools Shutting Down Your ComputerRemove the computer cover Back to Contents Replacing the Computer Cover Removing the Computer Cover Removing and Installing Parts PCI CardsReplace the computer cover AGP CardRemoving an AGP Card Installing an AGP Card MemoryMemory Installation Guidelines Installing Memory DDR Memory OverviewFront Panel Removing the Front Panel Replacing the Front PanelDrives Removing the Front-Panel InsertReplacing a Hard Drive Remove the front panelPage Adding or Replacing a Second Hard Drive Remove the existing hard driveReinstall the existing hard drive into the computer Adding a Floppy Drive Release and remove the front panelAdding a Second CD or DVD Drive Release and remove the front panel Microprocessor Removing the MicroprocessorPage Installing the Microprocessor Fan Assembly Removing the Fan AssemblyReplacing the Fan Assembly Remove the microprocessor heat sink Remove the fan assemblySystem Board Removing the System BoardRemoving the Power Supply Power SupplyInstalling the System Board Battery Replacing the Power SupplyBattery Overview Reinstall the fan assemblyReplacing the Battery Technical Specifications Ports and Connectors PowerVideo AudioEnvironmental System Setup Entering System SetupViewing Settings System Setup ScreensSystem Setup Options System Memory Channel Mode AGP ApertureCPU Information CPU Speed Bus SpeedBoot Sequence Clearing Forgotten Passwords Enter system setupRemove the computer cover Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments Output Voltage Minimum Current a Maximum Current A1DC Power Connector P1 DC Power Connector P2Pin Number Signal name AWG Wire Pin Number Signal Name 18-AWG WireDC Power Connectors P3, P5, P6, P8 and P9 DC Power Connector P4DC Power Connector P7 Pin Number Signal Name 22-AWG WireBack to Contents