Dell 4600 technical specifications Removing the Front Panel, Replacing the Front Panel

Page 15

Removing the Front Panel

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

1.Follow the procedures in "Before You Begin."

2.Release and remove the front panel:

a.Push the release lever to release the top tab.

b.Reach inside the computer and push the bottom tab towards you to release it (the middle tab releases automatically).

c.Rotate the front panel to separate it from the side hinges.

Replacing the Front Panel

To replace the front panel, attach the side hinges and then rotate the front panel until it snaps onto the front of the computer.

Image 15
Contents Abbreviations and Acronyms Advanced Troubleshooting Diagnostic LightsLight Pattern Problem Description Suggested Resolution Beep Codes System boardCode Cause System Messages Message Possible Cause Corrective ActionReseat the memory modules Back to Contents Shutting Down Your Computer Before You BeginGetting Started Recommended ToolsRemove the computer cover Back to Contents Replacing the Computer Cover Removing the Computer Cover PCI Cards Removing and Installing PartsAGP Card Removing an AGP CardReplace the computer cover Memory Installing an AGP CardDDR Memory Overview Memory Installation Guidelines Installing MemoryFront Panel Replacing the Front Panel Removing the Front PanelRemove the front panel DrivesRemoving the Front-Panel Insert Replacing a Hard DrivePage Remove the existing hard drive Adding or Replacing a Second Hard DriveReinstall the existing hard drive into the computer Release and remove the front panel Adding a Floppy DriveAdding a Second CD or DVD Drive Release and remove the front panel Removing the Microprocessor MicroprocessorPage Installing the Microprocessor Removing the Fan Assembly Fan AssemblyRemoving the System Board Replacing the Fan AssemblyRemove the microprocessor heat sink Remove the fan assembly System BoardPower Supply Installing the System BoardRemoving the Power Supply Reinstall the fan assembly BatteryReplacing the Power Supply Battery OverviewReplacing the Battery Technical Specifications Audio Ports and ConnectorsPower VideoEnvironmental System Setup Screens System SetupEntering System Setup Viewing SettingsSystem Setup Options Bus Speed System Memory Channel ModeAGP Aperture CPU Information CPU SpeedBoot Sequence Enter system setup Clearing Forgotten PasswordsRemove the computer cover Inside View of Your Computer System Board Components Technical OverviewOutput Voltage Minimum Current a Maximum Current A1 Power Supply DC Connector Pin AssignmentsPin Number Signal Name 18-AWG Wire DC Power Connector P1DC Power Connector P2 Pin Number Signal name AWG WirePin Number Signal Name 22-AWG Wire DC Power Connectors P3, P5, P6, P8 and P9DC Power Connector P4 DC Power Connector P7Back to Contents