Dell 2010 service manual Replacing a Hard Drive, Removing a Media Card Reader

Page 33

8Replace the computer cover on both the sides (see "Replacing the Computer Cover" on page 16).

9Connect the computer and other devices to an electrical outlet.

Replacing a Hard Drive

1Follow the procedures in "Before You Begin" on page 11.

2Remove the computer cover from both the sides (see "Removing the Computer Cover" on page 15).

3Check the documentation for the hard drive to verify that it is configured for your computer.

4Move the cables out of the way and slide the hard drive into the hard drive bay.

5Align and replace the four screws that secure the hard drive to the hard drive bay.

6Connect the power and data cables to the hard drive.

7Ensure that you connect the data cable to the system board connector, if you disconnected it while removing the hard drive. For the location of the SATA connectors, see "System Board Components" on page 8.

8Check all cables to be certain that they are properly connected and firmly seated.

9Replace the computer cover on both the sides (see "Replacing the Computer Cover" on page 16).

10Connect your computer and devices to electrical outlets, and then turn them on.

11See the documentation that came with the hard drive for instructions on installing any software required for drive operation.

12Check the System Setup for drive configuration changes (see "Entering System Setup" on page 69).

Removing a Media Card Reader

1Follow the procedures in "Before You Begin" on page 11.

Drives

33

Image 33
Contents W . d e l l . c o m s u p p o r t . d e l l . c o m July Contents PCI and PCI Express Cards Processor Fan Heat Sink Assembly Changing Boot Sequence for Inside View of Your Computer Technical OverviewSystem Board Components Cpufan DIMM1 Technical Overview Technical Specifications Recommended Tools Before You BeginTurning Off Your Computer Safety Instructions Before You Begin Before You Begin Removing the Computer Cover Computer CoverReplacing the Computer Cover Place the computer in an upright position Computer Cover Removing the Front Bezel Front BezelReplacing the Front Bezel Removing Memory Modules Memory ModulesReplacing Memory Modules Cutouts Securing clip snapped in position Memory Modules Removing PCI and PCI Express Cards PCI and PCI Express CardsScrew Card Replacing PCI and PCI Express Cards PCI and PCI Express Cards PCI and PCI Express Cards Installed Removing a Hard Drive DrivesPower cable Data cable Screws Removing a Media Card Reader Replacing a Hard DriveFlexBay USB cable Screws Replacing a Media Card Reader Break-away metal plate Removing an Optical Drive Power cable Data cable Screws Replacing an Optical Drive Drives Drives Drives Removing the Power Switch Module Power Switch ModuleHard drive activity light Replacing the Power Switch Module Power Switch Module Removing the Front I/O Panel Front I/O PanelReplacing the Front I/O Panel Front I/O Panel Front I/O Panel Removing the Processor Fan and Heat Sink Assembly Processor Fan and Heat Sink AssemblyProcessor Fan and Heat Sink Assembly Replacing the Processor Fan and Heat Sink Assembly Processor Fan and Heat Sink Assembly Removing the Processor ProcessorProcessor Release lever Socket Replacing the Processor Processor Removing the System Board System BoardLift the system board up and out Replacing the System Board System Board Removing the Power Supply Power SupplyReplacing the Power Supply Power Supply Power Supply Removing the Battery BatteryReplacing the Battery System Setup Entering System SetupOverview System Setup System Setup Options USB Controller-Enabled or Disabled Enabled by Load Defaults Changing Boot Sequence for the Current Boot Clearing Forgotten Passwords and Cmos Settings Click Drivers & Downloads→Select Model Flashing the BiosSystem Setup System Setup