5Gently slide the optical drive into place.
6Align the screw holes in the optical drive with the screw holes in the optical drive bay.
7Replace the four screws that secure the optical drive to the optical drive bay.
8Connect the power and data cables to the optical drive.
9Ensure that you connect the data cable to the system board connector, if you disconnected it while removing the optical drive. For the location of the SATA connectors, see "System Board Components" on page 8.
10Replace the front bezel (see "Replacing the Front Bezel" on page 20).
11Replace the computer cover on both the sides (see "Replacing the Computer Cover" on page 16).
12Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the optical drive for instructions on installing any software required for drive operation.
13Check the System Setup for drive configuration changes (see "Entering System Setup" on page 69).
40