w w w . d e l l . c o m s u p p o r t . d e l l . c o m
78Adding Parts
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
5Connect your computer and devices to electrical outlets, and turn them on.
6
7Click the General tab.
8To verify that the memory is installed correctly, check the amount of memory (RAM) listed (see page 90).
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions on page 9.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
Your Dell™ computer provides a connector for an AGP card.
1Shut down the computer (see page 22).
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
2Turn off any attached devices and disconnect them from their electrical outlets.
3Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4Open the computer cover (see page 66).