Dell Dimension 2100 technical specifications Lower 3.5-Inch Floppy Drive, Inch Drive

1Drive bay plate

To remove the upper 3.5-inch drive plate and install a new drive:

1.Remove the front panel.

2.Remove the 3.5-inch front panel insert.

3.Rotate the power supply away from the system board. While holding the power supply, place the computer in the upright position.

4.Remove the metal plate covering the bay by using a screwdriver to pop out the metal plate from the left or right side of the computer frame.

5.Remove the extra rails from the inside front of the computer frame.

6.Install the rails on the sides of the drive.

The rails are marked “L” for installation on the left side of the drive and “R” for the right side of the drive.

7.Slide the drive assembly into the drive bay.

8.Connect a power supply cable and drive cables to the drive.

Lower 3.5-Inch Floppy Drive

1Drive-release rail tabs (2)

To remove the 3.5-inch floppy drive from the lower bay:

1.Remove the front panel.

2.Rotate the power supply away from the system board.

3.While holding the power supply, place the computer in the upright position.

4.Disconnect the power and interface cables from the back of the floppy drive.

5.Press the two drive-release rail tabs, and slide the drive out of the drive bay.

Before you install the new drive, install the drive-release rails on the sides of the replacement floppy drive.

5.25-Inch Drive