Back to Contents Page
Removing and Replacing Parts: Dell™ Dimension™ 2100 System Reference
Overview | Hard Drive |
Precautionary Measures | Power Supply and Fan Assembly |
Recommended Tools | Control Panel |
Cover | Cards |
Rotating the Power Supply | Memory |
Front panel | Heat Sink |
Microprocessor | |
Upper | Battery |
Lower | System Board |
| |
|
|
Overview
Unless otherwise noted, each of the following procedures assumes:
•You have the recommended tools.
•You have performed the steps in "Precautionary Measures."
•You have removed the computer cover.
•You can replace or reinstall a part by performing the removal procedure in reverse order.
Precautionary Measures
Before you remove or replace parts in the computer, read the following caution for your personal safety and to prevent damage to the computer from electrostatic discharge (ESD).
CAUTION FOR YOUR PERSONAL SAFETY AND PROTECTION OF THE EQUIPMENT.
Before you start to work on the system, perform the following steps in the sequence listed:
1.Turn off your computer and all devices.
2.Ground yourself by touching an unpainted metal surface at the back of the computer before touching anything inside your computer.
While you work, periodically touch an unpainted metal surface on the computer to dissipate any static electricity that might harm internal components.
3.Disconnect any devices connected to the computer, including the monitor, from their electrical outlets to reduce the potential for personal injury or shock. Also, disconnect any telephone or telecommunication lines from the computer.
4.Disconnect the power cable to your computer, and then press the power button to ground the system board.
After you remove or replace parts in the computer, observe the following notice to prevent damage to the computer:
NOTICE: Make sure that all other computer cables are connected before connecting the computer to its electrical outlet.
Recommended Tools
•Small