Dell 8300 Message Possible Cause Corrective Action, Reseat the memory modules

Page 4

Message

Possible Cause

Corrective Action

 

 

 

8042 Gate-A20 error

The keyboard controller failed its test.

If you receive this message after you make changes in the system setup

 

 

program, enter the program and restore the original value(s).

 

 

 

Address Line Short!

An error in the address decoding circuitry in the

Reseat the memory modules.

 

memory has occurred.

 

C: Drive Error

The hard drive is not working or is not configured

Ensure that the drive is installed correctly in the computer and defined

 

correctly.

correctly in the system setup program.

C: Drive Failure

 

 

 

 

 

Cache Memory Bad, Do

The cache memory is not operating.

See "Contacting Dell" in your Owner's Manual for instructions on obtaining

Not Enable Cache

 

technical assistance.

CH-2 Timer Error

An error is occurring on the timer on the system

See "Contacting Dell" in your Owner's Manual for instructions on obtaining

 

board.

technical assistance.

CMOS Battery State

The system configuration information in the system

Enter the system setup program, verify the system configuration, and then

Low

setup program is incorrect or the battery charge

restart the computer.

 

may be low.

 

CMOS Checksum Failure

 

 

CMOS System Options

 

 

Not Set

 

 

CMOS Display Type

 

 

Mismatch

 

 

CMOS Memory Size

 

 

Mismatch

 

 

CMOS Time and Date

 

 

Not Set

 

 

 

 

 

Diskette Boot Failure

Drive A or B is present but has failed the BIOS POST.

Ensure that the drive is installed correctly in the computer and defined

 

 

correctly in the system setup program. Check the interface cable at both

 

 

ends.

 

 

 

DMA Error

Error in the DMA controller on the system board.

The keyboard or system board may need to be replaced.

DMA 1 Error

 

 

DMA 2 Error

 

 

FDD Controller

The BIOS cannot communicate with the floppy drive

Ensure that the floppy drive or the hard drive is installed correctly in the

Failure

or hard drive controller.

computer and defined correctly in the system setup program. Check the

 

 

interface cable at both ends.

HDD Controller

 

 

Failure

 

 

 

 

 

INTR1 Error

An interrupt channel on the system board failed to

The keyboard or system board may need to be replaced.

 

POST.

 

INTR2 Error

 

 

 

 

 

Invalid Boot Diskette

The operating system cannot be located on drive A

Enter the system setup program and confirm that drive A or drive C is

 

or drive C.

properly identified.

 

 

 

Keyboard Error

The BIOS has detected a stuck key.

Ensure that nothing is resting on the keyboard; if a key appears to be stuck,

 

 

carefully pry it up. If the problem persists, you may need to replace the

 

 

keyboard.

KB/Interface Error

An error occurred with the keyboard connector.

Ensure that nothing is resting on the keyboard; if a key appears to be stuck,

 

 

carefully pry it up. If the problem persists, you may need to replace the

 

 

keyboard.

 

 

 

No ROM Basic

The operating system cannot be located on drive A

Enter the system setup program and confirm that drive A or drive C is

 

or drive C.

properly identified.

 

 

 

Back to Contents Page

Image 4
Contents Dell Dimension 8300 Series Abbreviations and AcronymsDiagnostic Lights Advanced TroubleshootingLight Pattern Problem Description Suggested Resolution System Messages Beep CodesCode Cause Message Possible Cause Corrective Action Correctly in the system setup programReseat the memory modules Battery Shut down the computer through the Start menuOpen the computer cover Close the computer coverBack to Contents Before You Begin Getting StartedRecommended Tools Shutting Down Your ComputerInstalling a PCI Card CardsPCI Cards PCI Cards AGP CardsPage Removing a PCI Card AGP CardsRemoving an AGP Card Installing an AGP Card Closing the Computer Cover Opening the Computer Cover Replacing the Hard Drive DrivesRemoving a Hard Drive Installing a Hard Drive Adding a Second Hard Drive Adding or Replacing a Floppy Drive Adding or Replacing a CD/DVD Drive Installing a Floppy DriveRemove the front-panel inserts Removing a CD/DVD Drive Installing a CD/DVD Drive Front Panel Removing the Front PanelRemoving the Front-Panel Insert Removing the Front Panel Removing the Front-Panel InsertBack to Contents Addressing Memory with 4-GB Configurations Installing MemoryDDR Memory Overview Installing Memory MemoryShut down the computer through the Start menu Close the computer cover Microprocessor Removing the Microprocessor Installing the MicroprocessorRemoving the Microprocessor Page Installing the Microprocessor Close the computer cover Removing and Installing Parts Power Supply Removing the Power SupplyReplacing the Power Supply Removing the Power Supply Replacing the Power SupplyClose the computer cover Technical Specifications Connectors PowerDrives Controls and LightsEnvironmental System Board Removing the System BoardReplacing the System Board Removing the System Board Replacing the System BoardClose the computer cover System Setup Program Entering the System Setup ProgramViewing Settings System Setup ScreensOption Function Boot Sequence Changing Boot Sequence for the Current BootClearing Forgotten Passwords Hyper-ThreadingClick Hardware and click Device Manager Shut down the computerBack to Contents Looking Inside Your Computer Technical OverviewSystem Board DC Power Connectors Power SupplyPower Supply DC Connector Pin Assignments DC Power Connector P2 DC Power Connector P1Pin Number Signal name 18-AWG Wire IDE Interface Cable Connections for Dell-Installed Drives Placement of Dell-Installed CardsDC Power Connectors P3, P5, P6, P8, and P9 DC Power Connector P7Card Connector Card Description Back to Contents Abbreviations and Acronyms Turning Off Your Computer Turn off computer window, click Turn off
Related manuals
Manual 146 pages 54.14 Kb

8300 specifications

The Dell Dimension 8300 was a personal computer designed to cater to both home and office users, particularly popular during its release in the early 2000s. Known for its robust performance and innovative technologies, the 8300 showcased features that appealed to a wide range of computing needs.

At its core, the Dell 8300 was powered by Intel’s 4th generation Pentium 4 processors, allowing users to experience enhanced speed and efficiency for various applications. With clock speeds reaching up to 3.2 GHz, this processor delivered solid performance for multitasking, gaming, and multimedia applications. The system architecture supported Hyper-Threading technology, which enabled the processor to handle multiple tasks more efficiently by allowing each core to run two threads simultaneously.

One of the standout features of the Dell 8300 was its support for DDR SDRAM. This module offered increased memory bandwidth compared to previous generations, ultimately improving the overall performance of the computer when running applications or handling large files. The machine typically accommodated up to 2GB of RAM, which, in the context of its release period, provided ample memory to run multiple programs simultaneously without significant slowdowns.

In terms of storage, the Dell 8300 was typically equipped with a range of hard drives, often starting from 80GB and going up to 250GB or more. The inclusion of a SATA interface improved data transfer speeds, which was critical for users looking to store and retrieve large files like videos, photos, and software applications efficiently. Furthermore, the system was flexible enough to support additional drives and external storage solutions.

The graphical capabilities of the Dell 8300 included options for integrated graphics as well as dedicated graphics cards such as the NVIDIA GeForce series or ATI Radeon models. This versatility made the system suitable for both casual gaming and more demanding applications, such as graphic design and video editing.

Connectivity options were also a notable feature of the Dell 8300. Equipped with a range of USB ports, FireWire ports, and Ethernet connectivity, users had the freedom to connect multiple peripherals and access high-speed internet with ease. The inclusion of various expansion slots meant that users could upgrade the system over time, adapting to new technologies as they emerged.

Additionally, the Dell Dimension 8300 featured an attractive design with a spacious case that allowed for good airflow and easier upgrades, making it an appealing choice for users looking to enhance their systems. Furthermore, the combination of reliability, performance, and upgrade potential helped solidify the 8300 as a noteworthy contender in the desktop market during its era.