NETGEAR XS712T manual Device Hardware Interfaces, Port LEDs, System LEDs

XS712T Smart Switch

Port LEDs

The following table describes the RJ-45 and combo SFP+ port LED designations. Each RJ-45 port has two LEDs. Each SFP+ port has its own indication LEDs.

Table 1. Port LEDs

LED	Designation
Link/Speed/ACT LED mode for	•	Off. No link established.
copper ports 1 to 12	•	Solid green (left side). A valid 10-Gbps link is established.
	• Blinking green (left side). The port is transmitting or receiving
		packets at 10 Gbps.
	• Solid yellow (right side). A valid 100/1000-Mbps link is established.
	• Blinking yellow (right side). The port is transmitting or receiving
		packets at 100/1000 Mbps.
Link/ACT LED for SFP+ ports	•	Off. No SFP+ module link is established.
11 and 12	•	Solid green (left side). A valid 10-Gbps link is established.
	• Blinking green (left side). The port is transmitting or receiving
		packets at 10 Gbps.
	• Solid yellow (right side). A valid 1000-Mbps link is established on
		the port.
	• Blinking yellow (right side). The port is transmitting or receiving
		packets at 1000 Mbps.

System LEDs

The following table describes the system LED designations.

Table 2. System LEDs

LED	Designation
Power	•	Solid green. The device is powered on; runtime code is operating.
	• Solid yellow. The device is booting up.
	• Off. Power is not supplied to the device.
Fan	•	Solid yellow. The fan has experienced a failure.
	• Off. The fan is operating normally.

Device Hardware Interfaces

The following sections describe the hardware interfaces on the device.

11