NETGEAR XS712T manual Backbone switching

Page 15

XS712T Smart Switch

XS712T

*67;6;67

										7	7
											)	)

Model FS728TP

Model GS108T

C	C	C	C
	C

Figure 5. Backbone switching

15

Image 15

Contents XS712T Smart Switch Support TrademarksRevision History Contents Appendix C Notification of Compliance Introduction Overview FeaturesPackage Contents XS712T Smart Switch Physical Description LED Designations Front Panel and Back Panel ConfigurationDevice Hardware Interfaces Port LEDsSystem LEDs SFP+ Ports Reset ButtonFactory Defaults Button RJ-45 PortsApplications Backbone Switching Desktop SwitchingBackbone switching Installation Prepare the Site Install the SwitchInstall the Switch on a Flat Surface  To install the switch on a flat surface To install the switch in a rack Check the InstallationConnect Devices to the Switch Install the Switch in a RackInstall an SFP Transceiver Module  To connect devices to the switch To install an SFP transceiver  To apply AC power Apply AC PowerXS712T Smart Switch Troubleshooting Network Adapter Cards Troubleshooting ChartAdditional Troubleshooting Suggestions ConfigurationAutonegotiation Switch IntegrityTechnical Specifications Management Network Protocol and Standards CompatibilityEnvironmental Specifications Performance SpecificationsPower Supply Physical SpecificationsSafety FCC Requirements for Operation in the United States Netgear Wired ProductsRegulatory Compliance Information Europe EU Declaration of ConformityXS712T Smart Switch FCC Guidelines for Human Exposure