NETGEAR XS712T manual Package Contents

XS712T Smart Switch

-IEEE802.3ae (10GBASE Ethernet)

-IEEE802.3az (Energy Efficient Ethernet)

-IEEE 802.3x (full-duplex flow control)

•AutoSensing and autonegotiating capabilities for all ports.

•Auto Uplink™ on all ports to make the right connection.

•Automatic address learning function to build the packet-forwarding information table. The table contains up to 32K Media Access Control (MAC) addresses.

•Store-and-forward transmission to remove bad packets from the network.

•Full-duplex IEEE 802.3x pause frame flow control.

•Active flow control to minimize packet loss and frame drops.

•Half-duplex backpressure control.

•Per-port LEDs and Power LED.

•Internal open frame power supply.

•Standard NETGEAR 7xx series chassis (1U high).

Package Contents

The following figure shows the package contents of the smart switch.

																																																						GS752TXSXS712T
Powerer		Link/Act Mode	—	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17	18	19	20	21	22	23	24	25	26	27	28	29	30	31	32	33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48	49F	50F	51F	52F
Fan		Green=Link at 1G																						1		2		3		4			5		6		7		8			9		10		11T		12T
		Yellow=Link at 10/
Stack		100M
Master	ID																																																						SFP
																																																							+
																																																			11F		12F
Reset	Factory																																																			Green=10G Link Yellow=1G
	Defaults																																																				Blink=ACT

Figure 1. Package contents

Verify that the package contains the following:

•XS712T Smart Switch

7