NETGEAR XS712T manual Netgear Wired Products, Regulatory Compliance Information

Page 29

C.Notification of Compliance

NETGEAR Wired Products

Regulatory Compliance Information

C

This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.

This product's firmware limits operation to only the channels allowed in a particular Region or Country. Therefore, all options described in this user's guide may not be available in your version of the product.

Europe – EU Declaration of Conformity

Products bearing the marking comply with the following EU directives:

EMC Directive 2004/108/EC

Low Voltage Directive 2006/95/EC

If this product has telecommunications functionality, it also complies with the requirements of the following EU Directive:

R&TTE Directive 1999/5/EC

Compliance with these directives implies conformity to harmonized European standards that are noted in the EU Declaration of Conformity.

FCC Requirements for Operation in the United States

FCC Information to User

This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

29

Image 29
Contents XS712T Smart Switch Revision History SupportTrademarks Contents Appendix C Notification of Compliance Introduction Overview FeaturesPackage Contents XS712T Smart Switch Physical Description LED Designations Front Panel and Back Panel ConfigurationSystem LEDs Device Hardware InterfacesPort LEDs Factory Defaults Button Reset ButtonRJ-45 Ports SFP+ PortsApplications Backbone Switching Desktop SwitchingBackbone switching Installation Install the Switch on a Flat Surface Install the Switch To install the switch on a flat surface Prepare the SiteConnect Devices to the Switch Check the InstallationInstall the Switch in a Rack  To install the switch in a rack To install an SFP transceiver Install an SFP Transceiver Module To connect devices to the switch  To apply AC power Apply AC PowerXS712T Smart Switch Troubleshooting Additional Troubleshooting Suggestions Troubleshooting ChartConfiguration Network Adapter CardsAutonegotiation Switch IntegrityTechnical Specifications Management Network Protocol and Standards CompatibilityPower Supply Performance SpecificationsPhysical Specifications Environmental SpecificationsSafety Regulatory Compliance Information Netgear Wired ProductsEurope EU Declaration of Conformity FCC Requirements for Operation in the United StatesXS712T Smart Switch FCC Guidelines for Human Exposure