NETGEAR manual XS712T Smart Switch

Page 21

XS712T Smart Switch

managing the switch, see the software administration manual on the smart switch resource CD.

Note: The switch is configured with a default IP address of 192.168.0.239 and a subnet mask of 255.255.255.0.

21

Image 21

Contents XS712T Smart Switch Support TrademarksRevision History Contents Appendix C Notification of Compliance Introduction Overview FeaturesPackage Contents XS712T Smart Switch Physical Description LED Designations Front Panel and Back Panel ConfigurationDevice Hardware Interfaces Port LEDsSystem LEDs Factory Defaults Button Reset ButtonRJ-45 Ports SFP+ PortsApplications Backbone Switching Desktop SwitchingBackbone switching Installation Install the Switch on a Flat Surface Install the Switch To install the switch on a flat surface Prepare the SiteConnect Devices to the Switch Check the InstallationInstall the Switch in a Rack  To install the switch in a rackInstall an SFP Transceiver Module  To connect devices to the switch To install an SFP transceiver  To apply AC power Apply AC PowerXS712T Smart Switch Troubleshooting Additional Troubleshooting Suggestions Troubleshooting ChartConfiguration Network Adapter CardsAutonegotiation Switch IntegrityTechnical Specifications Management Network Protocol and Standards CompatibilityPower Supply Performance SpecificationsPhysical Specifications Environmental SpecificationsSafety Regulatory Compliance Information Netgear Wired ProductsEurope EU Declaration of Conformity FCC Requirements for Operation in the United StatesXS712T Smart Switch FCC Guidelines for Human Exposure