Universal Pass Through WiFi Range Extender WN3100RP
CAUTION:
Once you start the firmware upgrade, do not try to go online, turn off the extender, shut down the computer, or do anything else to the extender until it finishes restarting.
Advanced Wireless Settings
The extender is set up with the optimum settings. Do not alter these settings unless directed by NETGEAR support. Incorrect settings might disable the extender unexpectedly.
To view or change the advanced wireless settings:
1.Select Advanced > Wireless Settings. The following screen displays:
2.View or configure the following settings:
•Enable Wireless Access Point. Select this check box to enable the extender to work as a wireless access point. If this check box is cleared, then computers or wireless devices cannot connect wirelessly to the extender.
•Enable SSID Broadcast. Select this check box to enable the extender to broadcast its wireless network name (SSID). If this check box is cleared, then the wireless network is hidden. To join a hidden wireless network, type the wireless name.
•Disable Device’s PIN. Select this check box to disable the extender’s PIN. The PIN can be used for a WPS wireless connection.
•Keep Existing Wireless Settings. Select this check box to keep the settings in the Wireless Settings screen unchanged when a wireless connection is made with WPS.
•Setup Access List. Specify a list of computers or wireless devices that are allowed to connect to the network.
Extender Network Settings
37