D-Link DI-707PD manual Resetting the DI-707P to the Factory Default Settings

Page 70

Resetting the DI-707P to the Factory Default Settings

After you have tried other methods for troubleshooting your network, you may choose to Reset the DI-707P to the factory default settings.

To hard-reset the D-Link DI-707P to the Factory Default Settings, please do the following:

Turn off the DI-707P

Locate the Reset button on the back of the DI-707P

Use a paper clip to press the Reset button and power on.

Hold for about 5 seconds (don’t hold too long) and then release. (Or, release when M1 and M2 flash at the same time.)

After you have completed the above steps, the DI-707P will be reset to the factory default settings

69

Image 70
Contents Link DI-707P Page Contents Package Contents Introduction Connections Introduction to Broadband Router Technology Introduction to Firewalls Introduction to Virtual Private Networking Leds Getting Started Using the Configuration Menu PPP over Ethernet Home WAN Choose WAN TypeDynamic IP Address OthersRenew IP Forever Home WAN Dynamic IP AddressHost Name MAC AddressHome WAN Static IP Address PPPoE Account PPPoE Password Primary DNS Home WAN PPPoEHome WAN Pptp Home WAN BigPond Cable PasswordLogin Server AccountDomain Name Home LANSubnet Mask Dhcp ServerServices EnableService Ports Service IPTrigger Advanced ApplicationIncoming Ports Advanced MAC Filters Enabled or Disabled Advanced IP FilterAdvanced Domain Filter Enable SNMP- Local Remote Get Community Advanced SnmpAdvanced Ddns Password/KeyProvider Advanced DMZ Advanced Routing Tools Admin Password Remote Management IP AddressTools Time Set Device Date TimeTools System Tools Firmware BrowseTools Misc Status Device Info Status Log Status Log Settings Help Installing the Print Server Software Click OK Configuring on Windows 98SE/ME Platforms Configuring on Windows XP/2000/NT Platforms Networking Basics Networking Basics Enter a Computer description and a Computer name optional Networking Basics Networking Basics Networking Basics Network Setup Wizard Naming your Computer Right-click on My ComputerChecking the IP Address in Windows XP Computer nameAssigning a Static IP Address in Windows XP/2000 Network Connections Assigning a Static IP Address Windows XP/2000 Click on Internet Protocol TCP/IP Click PropertiesAssigning a Static IP Address with Macintosh OSX Select Built-in EthernetSelecting a Dynamic IP Address with Macintosh OSX Adding and Sharing Printers in Windows XP Other Networking TasksStart Printers Faxes Click on Add a printer Adding a local printer Select Local printer attached to this computerNetworking Basics Adding a local printer Adding a local printer Sharing a network printer Go to Start Printers and FaxesNetworking Basics Sharing a network printer Select Browse for a printer Go to Start Printers and Faxes Sharing an LPR printer Networking Basics Sharing an LPR printer Select Create a new portCustom Click Have Disk This screen will display information about your printer Resetting the DI-707P to the Factory Default Settings Technical Specifications Contacting Technical Support Warranty and Registration Page 11/27/2002