D-Link DIR-455 manual IKE Proposal Settings, Ipsec Proposal Settings

Page 37

Section 3 - Configuration

IKE PROPOSAL SETTINGS

DH Group: Three groups can be selected: group 1 (MODP768), group 2 (MODP1024), and group 5 (MODP1536).

Encryption Algorithm: Three algorithms can be selected: 3DES, DES, and AES.

Authentication Algorithm: Two algorithms can be selected: SHA1 and MD5.

Enable: Select this checkbox to enable the IKE Proposal with this rule.

IPSEC PROPOSAL SETTINGS

Encryption Algorithm: Three algorithms can be selected: 3DES, DES and AES. However, when the encapsulation protocol is set to AH, the encryption algorithm is unnecessary.

Authentication Algorithm: Two algorithms can be selected: SHA1 and MD5.

D-Link DIR-455 User Manual

33

Image 37

Contents Page Trademarks PrefaceTable of Contents Troubleshooting Wireless Basics ProductPackageOverviewContents Introduction Hardware Overview PowerRear Panel LAN4 LAN3 LAN2 LAN1 WAN SIMWAN LAN1 LAN2 LAN3 LAN4 Front PanelWPS SMS WlanWAN LEDsConnect to Your Network InstallationConnect a Telephone Wireless Installation Considerations Web-based Configuration Utility ConfigurationInternet Connection Setup Wizard Setup WizardClick Internet Connection Setup Wizard to begin Manual Internet Connection Setup and skip toPage Page Page Click Manual Internet Connection Setup to begin Manual Internet Connection SetupInternet Connection Type Internet ConnectionDynamic IP Dhcp PPPoE Reconnect Mode Address ModePptp IP Address Pptp Subnet MaskL2TP Subnet Mask L2TP IP AddressDialed Number AuthenticationKeep Alive Static IP GRE Tunnel GRE SettingsTunnels Information Wireless Network Settings Wireless SettingsMode Wireless Security Mode Router Settings Network SettingsEnable Dhcp Server Dhcp Server SettingsDhcp Lease Time Secondary Wins IP AddressVPN Settings Page Encapsulation Protocol ESP, AH, or ESP+AH Tunnel 1 IKEPage Page Ipsec Proposal Settings IKE Proposal SettingsTunnel 1 Manual Key Page Encapsulation Protocol ESP, AH, or ESP+AH PFS Group XAuth Server ModePreshared Key Remote IDIKE Proposal Settings SMS Inbox Message ServiceCreate Message Receiver CancelInbox RefreshVirtual Server EnableCopy to Virtual Servers ListApplication Rules Application RulesQOS Packet Filter QoS EngineLocal IP Ports QoS PriorityMAC Address Filter MAC Filtering SettingsMAC Filtering Rules URL Filtering Rules URL FilterOutbound Filter Outbound Filter SettingOutbound Filter Rules List Inbound Filter Intbound Filter SettingInbound Filter Rules List Set Community SnmpRouting RIP SettingRouting Rules Dtim Interval WMM Capable TX Rates Advanced WirelessUpnp Advanced NetworkWAN Ping Administrator AdminRemote Management Time ConfigurationTime Zone Set the Time and DateSyslog Mail Settings System Firmware Username / E-mail Enter the Username for your Dynamic DNSSystem Check Schedules Device Information Logs Statistics Wireless Support What is WEP? Wireless SecurityNext to Security Mode, select Enable WEP Security Configure WEPWhat is WPA? Configure WPA-PSK Configure WPA Radius Using Windows Vista Connect to a Wireless NetworkConfigure Wireless Security Page Using Windows XP Configure WEP Page Configure WPA-PSK Page Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Wireless Basics Wireless Personal Area Network Wpan Wireless Local Area Network WlanSmall Office and Home Office HomeEliminate Interference Centralize your Router or Access PointSecurity Wireless Modes Check your IP address Networking BasicsStep Statically Assign an IP addressGSM Band GSM/GPRS/EDGE Technical SpecificationsDimensions L x W x H