D-Link DIR-455 manual Receiver, Cancel, Inbox, Refresh, Sms

Page 44

Section 3 - Configuration

CREATE MESSAGE

Receiver:

Text Message:

Sent Message:

Cancel:

This page allows you to send an SMS to your contacts. Just fill in the phone number of the recipient, and type the content of message. Then push the “Send Message” button to send out this message. If you would like to add more than one recipient, you must put a semicolon (;) between each of the phone numbers.

Type the phone number of the recipient.

Type the message that you would like to send.

Click this button to send the message.

Click this button to cancel message input.

INBOX

Delete Message: Reply Message:

Refresh:

This page shows all messages that are stored on the SIM card. Selecting a message, and the content will be shown in the SMS window. After you read it, you can delete it, or reply to the sender. Push the “Refresh” button to update the list.

SMS

Deletes the selected SMS message.

Replies to the selected SMS message.

Click this button to check for new messages.

D-Link DIR-455 User Manual

40

Image 44

Contents Page Preface TrademarksTable of Contents Troubleshooting Wireless Basics ProductPackageOverviewContents Introduction Power Hardware OverviewRear Panel LAN4 LAN3 LAN2 LAN1 WAN SIMFront Panel WAN LAN1 LAN2 LAN3 LAN4WPS SMS WlanLEDs WANInstallation Connect to Your NetworkConnect a Telephone Wireless Installation Considerations Configuration Web-based Configuration UtilitySetup Wizard Internet Connection Setup WizardClick Internet Connection Setup Wizard to begin Manual Internet Connection Setup and skip toPage Page Page Manual Internet Connection Setup Click Manual Internet Connection Setup to beginInternet Connection Internet Connection TypeDynamic IP Dhcp PPPoE Address Mode Reconnect ModePptp IP Address Pptp Subnet MaskL2TP IP Address L2TP Subnet MaskKeep Alive AuthenticationDialed Number Static IP GRE Settings GRE TunnelTunnels Information Mode Wireless SettingsWireless Network Settings Wireless Security Mode Network Settings Router SettingsDhcp Server Settings Enable Dhcp ServerDhcp Lease Time Secondary Wins IP AddressVPN Settings Page Tunnel 1 IKE Encapsulation Protocol ESP, AH, or ESP+AHPage Page IKE Proposal Settings Ipsec Proposal SettingsTunnel 1 Manual Key Page Encapsulation Protocol ESP, AH, or ESP+AH XAuth Server Mode PFS GroupPreshared Key Remote IDIKE Proposal Settings Create Message Message ServiceSMS Inbox Cancel ReceiverInbox RefreshEnable Virtual ServerCopy to Virtual Servers ListApplication Rules Application RulesQoS Engine QOS Packet FilterLocal IP Ports QoS PriorityMAC Filtering Rules MAC Filtering SettingsMAC Address Filter URL Filter URL Filtering RulesOutbound Filter Rules List Outbound Filter SettingOutbound Filter Inbound Filter Rules List Intbound Filter SettingInbound Filter Snmp Set CommunityRouting Rules RIP SettingRouting Advanced Wireless Dtim Interval WMM Capable TX RatesWAN Ping Advanced NetworkUpnp Remote Management AdminAdministrator Configuration TimeTime Zone Set the Time and DateSyslog Mail Settings System Firmware Dynamic DNS Username / E-mail Enter the Username for yourSystem Check Schedules Device Information Logs Statistics Wireless Support Wireless Security What is WEP?Configure WEP Next to Security Mode, select Enable WEP SecurityWhat is WPA? Configure WPA-PSK Configure WPA Radius Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Page Using Windows XP Configure WEP Page Configure WPA-PSK Page Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Wireless Basics Wireless Local Area Network Wlan Wireless Personal Area Network WpanHome Small Office and Home OfficeSecurity Centralize your Router or Access PointEliminate Interference Wireless Modes Networking Basics Check your IP addressStatically Assign an IP address StepTechnical Specifications GSM Band GSM/GPRS/EDGEDimensions L x W x H