D-Link DIR-455 manual Mail Settings

Page 59

Section 3 - Configuration

E-mail Settings

E-mail Settings allows you to send the system log files, router alert messages, and firmware update notifications to an e-mail address.

Enable E-mail Notification: When this option is enabled, router activity logs are e-mailed to a designated e-mail address.

SMTP Sever IP and Port: Enter the SMTP server IP address followed by a colon and the port number (e.g. 123.123.123.1:25).

Send E-mail Alert to: Enter the e-mail address where you would like the e-mail sent to.

E-mail Subject: Enter a subject for the e-mail.

Test E-mail Alert: Click this button to send a test e-mail using the settings specified on this page.

Click Save Settings to save your changes, or click Don’t Save Settings to discard your changes.

D-Link DIR-455 User Manual

55

Image 59

Contents Page Trademarks PrefaceTable of Contents Troubleshooting Wireless Basics ProductPackageOverviewContents Introduction LAN4 LAN3 LAN2 LAN1 WAN SIM PowerHardware Overview Rear PanelSMS Wlan Front PanelWAN LAN1 LAN2 LAN3 LAN4 WPSWAN LEDsConnect to Your Network InstallationConnect a Telephone Wireless Installation Considerations Web-based Configuration Utility ConfigurationManual Internet Connection Setup and skip to Setup WizardInternet Connection Setup Wizard Click Internet Connection Setup Wizard to beginPage Page Page Click Manual Internet Connection Setup to begin Manual Internet Connection SetupInternet Connection Type Internet ConnectionDynamic IP Dhcp PPPoE Pptp Subnet Mask Address ModeReconnect Mode Pptp IP AddressL2TP Subnet Mask L2TP IP AddressKeep Alive AuthenticationDialed Number Static IP GRE Tunnel GRE SettingsTunnels Information Mode Wireless SettingsWireless Network Settings Wireless Security Mode Router Settings Network SettingsSecondary Wins IP Address Dhcp Server SettingsEnable Dhcp Server Dhcp Lease TimeVPN Settings Page Encapsulation Protocol ESP, AH, or ESP+AH Tunnel 1 IKEPage Page Ipsec Proposal Settings IKE Proposal SettingsTunnel 1 Manual Key Page Encapsulation Protocol ESP, AH, or ESP+AH Remote ID XAuth Server ModePFS Group Preshared KeyIKE Proposal Settings Create Message Message ServiceSMS Inbox Refresh CancelReceiver InboxVirtual Servers List EnableVirtual Server Copy toApplication Rules Application RulesQoS Priority QoS EngineQOS Packet Filter Local IP PortsMAC Filtering Rules MAC Filtering SettingsMAC Address Filter URL Filtering Rules URL FilterOutbound Filter Rules List Outbound Filter SettingOutbound Filter Inbound Filter Rules List Intbound Filter SettingInbound Filter Set Community SnmpRouting Rules RIP SettingRouting Dtim Interval WMM Capable TX Rates Advanced WirelessWAN Ping Advanced NetworkUpnp Remote Management AdminAdministrator Set the Time and Date ConfigurationTime Time ZoneSyslog Mail Settings System Firmware Username / E-mail Enter the Username for your Dynamic DNSSystem Check Schedules Device Information Logs Statistics Wireless Support What is WEP? Wireless SecurityNext to Security Mode, select Enable WEP Security Configure WEPWhat is WPA? Configure WPA-PSK Configure WPA Radius Using Windows Vista Connect to a Wireless NetworkConfigure Wireless Security Page Using Windows XP Configure WEP Page Configure WPA-PSK Page Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Wireless Basics Wireless Personal Area Network Wpan Wireless Local Area Network WlanSmall Office and Home Office HomeSecurity Centralize your Router or Access PointEliminate Interference Wireless Modes Check your IP address Networking BasicsStep Statically Assign an IP addressGSM Band GSM/GPRS/EDGE Technical SpecificationsDimensions L x W x H