D-Link DIR-455 manual Copy to, Virtual Servers List, Server IP Port, Enable

Page 45

Section 3 - Configuration

Virtual Server

The device can be configured as a virtual server so that users can access services such as Web or FTP via the public (WAN) IP address of the router.

Well-known Services: This contains a list of pre-defined services.

Copy to:

Copies the rule to the line of the

 

specified ID.

Use schedule rule:

You may select Always On or

 

choose the number of a schedule

 

rule that you have defined.

 

VIRTUAL SERVERS LIST

ID:

Identifies the virtual server.

Server IP: Port:

Enter the last digits of the IP

 

address of the computer on your

 

local network that you want to allow

 

the incoming service. In the next

 

box, enter the port number that you

 

would like to open.

Enable:

Select this box to enable the rule.

Schedule Rule #:

Specify the schedule rule

 

number.

 

Click Save Settings to save your changes, or click Don’t Save Settings to discard your changes.

D-Link DIR-455 User Manual

41

Image 45
Contents Page Trademarks PrefaceTable of Contents Troubleshooting Wireless Basics ProductPackageOverviewContents Introduction Hardware Overview PowerRear Panel LAN4 LAN3 LAN2 LAN1 WAN SIMWAN LAN1 LAN2 LAN3 LAN4 Front PanelWPS SMS WlanWAN LEDsConnect to Your Network InstallationConnect a Telephone Wireless Installation Considerations Web-based Configuration Utility ConfigurationInternet Connection Setup Wizard Setup WizardClick Internet Connection Setup Wizard to begin Manual Internet Connection Setup and skip toPage Page Page Click Manual Internet Connection Setup to begin Manual Internet Connection SetupInternet Connection Type Internet ConnectionDynamic IP Dhcp PPPoE Reconnect Mode Address ModePptp IP Address Pptp Subnet MaskL2TP Subnet Mask L2TP IP AddressAuthentication Dialed NumberKeep Alive Static IP GRE Tunnel GRE SettingsTunnels Information Wireless Settings Wireless Network SettingsMode Wireless Security Mode Router Settings Network SettingsEnable Dhcp Server Dhcp Server SettingsDhcp Lease Time Secondary Wins IP AddressVPN Settings Page Encapsulation Protocol ESP, AH, or ESP+AH Tunnel 1 IKEPage Page Ipsec Proposal Settings IKE Proposal SettingsTunnel 1 Manual Key Page Encapsulation Protocol ESP, AH, or ESP+AH PFS Group XAuth Server ModePreshared Key Remote IDIKE Proposal Settings Message Service SMS InboxCreate Message Receiver CancelInbox RefreshVirtual Server EnableCopy to Virtual Servers ListApplication Rules Application RulesQOS Packet Filter QoS EngineLocal IP Ports QoS PriorityMAC Filtering Settings MAC Address FilterMAC Filtering Rules URL Filtering Rules URL FilterOutbound Filter Setting Outbound FilterOutbound Filter Rules List Intbound Filter Setting Inbound FilterInbound Filter Rules List Set Community SnmpRIP Setting RoutingRouting Rules Dtim Interval WMM Capable TX Rates Advanced WirelessAdvanced Network UpnpWAN Ping Admin AdministratorRemote Management Time ConfigurationTime Zone Set the Time and DateSyslog Mail Settings System Firmware Username / E-mail Enter the Username for your Dynamic DNSSystem Check Schedules Device Information Logs Statistics Wireless Support What is WEP? Wireless SecurityNext to Security Mode, select Enable WEP Security Configure WEPWhat is WPA? Configure WPA-PSK Configure WPA Radius Using Windows Vista Connect to a Wireless NetworkConfigure Wireless Security Page Using Windows XP Configure WEP Page Configure WPA-PSK Page Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Wireless Basics Wireless Personal Area Network Wpan Wireless Local Area Network WlanSmall Office and Home Office HomeCentralize your Router or Access Point Eliminate InterferenceSecurity Wireless Modes Check your IP address Networking BasicsStep Statically Assign an IP addressGSM Band GSM/GPRS/EDGE Technical SpecificationsDimensions L x W x H