Linksys WRV200 manual Appendix, Regulatory Information

Page 66

Appendix I

Appendix I: Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna

•Increase the separation between the equipment or devices

•Connect the equipment to an outlet other than the receiver’s

•Consult a dealer or an experienced radio/TV technician for assistance

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to channels 1 through 11.

Regulatory Information

Safety Notices

•Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord.

•Do not use this product near water, for example, in a wet basement or near a swimming pool.

•Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

WARNING: This product contains lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.

Industry Canada Statement

This Class B digital apparatus complies with Canadian ICES-003 and RSS210.

Operation is subject to the following two conditions:

1.This device may not cause interference and

2.This device must accept any interference, including interference that may cause undesired operation of the device. This device has been designed to operate with an antenna having a maximum gain of 2dBi. Antenna havingahighergainisstrictlyprohibitedperregulations of Industry Canada. The required antenna impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP is not more than required for successful communication.

Industry Canada Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Wireless-G VPN Router with RangeBooster

61

Page 65 Page 67
Image 66
Page 65 Page 67
Contents Wireless-G VPN Router with RangeBooster About This Guide About This GuideTable of Contents Appendix a Troubleshooting Appendix B Wireless Security ChecklistAppendix E Gateway-to-Gateway VPN Tunnel Appendix I Regulatory InformationAppendix J Contact Information Chapter IntroductionNetwork Topology Chapter Planning Your Wireless NetworkAd-Hoc versus Infrastructure Mode Network LayoutWhy do I need a VPN? What is a VPN?Chapter Planning Your Virtual Private Network VPN Computer using the Linksys VPN client software to VPN Router VPN Router to VPN RouterFront Panel Chapter Product OverviewProduct Overview Back PanelChapter Configuring the Wireless-G VPN Router OverviewSetup Basic Settings How to Access the Web-based UtilitySetup Internet SetupPptp Optional Settings Required by some ISPs LAN SetupSetup Vlan Setup DdnsTime Settings Setup MAC Address Clone DdnsSetup Advanced Routing Dynamic RoutingStatic Routing Wireless Wireless Security WirelessWireless Basic Wireless Settings Wireless Network ModeWPA2 Personal WPA EnterpriseWPA2 Enterprise WPA2 Personal Mixed WPA2 Enterprise MixedWireless Wireless Network Access Wireless Network AccessWireless Advanced Wireless Settings Wireless WDSAdvanced Wireless Settings Firewall Port Forwarding FirewallFirewall General Internet BlockFirewall Port Triggering Firewall DMZFirewall Access Restriction VPN VPN Client AccessFirewall URL Filtering VPN VPN Passthrough VPN Client List TableCertificate Management VPN IPSec VPN Local Secure GroupRemote Secure Group Remote Secure Gateway Key ManagementTunnel Options VPN VPN Summary QoS Port-Based QoS QoSQoS Application-Based QoS Priority QueueAdmin Password AdministrationAdministration Management Local Router AccessAdministration Log Backup and RestoreUPnP Administration Firmware Upgrade Administration DiagnosticsAdministration Factory Default Ping TestStatus Router Administration RebootStatus InformationStatus System Performance Status WirelessStatus Local Network Local NetworkStatus VPN Clients System PerformanceVPN Summary Appendix a Appendix a TroubleshootingTroubleshooting WindowsTroubleshooting Need to set up a server behind my Router Click Save Settings Go to the Firewall DMZ tabGo to the Setup Basic Setup tab Click the Firewall Port Triggering tabFrequently Asked Questions WRV200 does not support NetBIOS Broadcast overIs the Router cross-platform compatible? Appendix B Appendix B Wireless Security ChecklistWireless Security Checklist General Network Security GuidelinesAppendix C Installing from the CD-ROMAppendix C Overview Before You BeginUsing the Linksys QuickVPN Software Version Number of the QuickVPN ClientSelect VPN, then VPN Client Access Distributing Certificates to QuickVPN Users\Program Files\Linksys\QuickVPN Client\ Environment Appendix DIntroduction Create an IPSec PolicyFilter List 2 router win Configure Individual Tunnel Rules Tunnel 1 win-RouterTunnel 2 Router-win Rules Tab Assign New IPSec Policy Create a Tunnel Through the Web-Based UtilityYour tunnel should now be established Appendix E Gateway-to-Gateway VPN Tunnel Configuration of the WRV200Appendix E Click IPSec VPNConfiguration of the RV082 Configuration of PC 1 and PCClick the Gateway to Gateway tab RV082 WRV200 Dynamic IP B.B.B.B with Configuration when Both Gateways Use Dynamic IP Addresses RV082 VPN Settings Glossary Appendix FAppendix F Glossary Http HyperText Transport ProtocolGlossary Smtp Simple Mail Transfer Protocol The standard eAppendix F Appendix G Specifications SpecificationsAppendix G Specifications Appendix H Warranty InformationObtaining Warranty Service Exclusions and LimitationsWarranty Information Technical SupportAppendix Regulatory InformationWireless Disclaimer Avis d’Industrie CanadaDansk Danish Miljøinformation for kunder i EU Appendix Norsk Norwegian Miljøinformasjon for kunder i EU Appendix Appendix J Contact Information
Related manuals
Manual 2 pages 11.27 Kb
Top Page Image Contents