NETGEAR DG834Gv5 manual Troubleshooting the ISP Connection, Adsl link

Page 32

Click the Refresh or Reload button in the Web browser. The changes may have occurred, but the Web browser may be caching the old configuration.

Troubleshooting the ISP Connection

If your router is unable to access the Internet, you should check the ADSL connection, then the Internet TCP/IP connection.

ADSL link

If your router is unable to access the Internet, you should first determine whether you have an ADSL link with the service provider. The state of this connection is indicated with the Internet LED.

Internet LED Green or Blinking Green

If your ADSL Internet LED is green or blinking green, then you have a good ADSL connection. You can be confident that the service provider has connected your line correctly and that your wiring is correct.

Internet LED Red

The Internet connection failed. Disconnect all telephones on the line. If this solves the problem, reconnect the telephones one at a time, being careful to use a microfilter on each telephone. If the microfilters are connected correctly, you should be able to connect all your telephones.

If disconnecting telephones does not result in a green ADSL Internet LED, there may be a problem with your wiring. If the telephone company has tested the ADSL signal at your Network Interface Device (NID), then you may have poor quality wiring in your house.

ADSL Internet LED Off

If the ADSL Internet LED is off, disconnect all telephones on the line. If this solves the problem, reconnect the telephones one at a time, being careful to use a microfilter on each telephone. If the microfilters are connected correctly, you should be able to connect all your telephones.

If disconnecting telephones does not result in a green ADSL Internet LED the problem may be one of the following:

Check that the telephone company has made the connection to your line and tested it.

28

Troubleshooting

Image 32
Contents Wireless ADSL2+ Modem Router Setup Manual NETGEAR, IncTrademarks Contents Technical Specifications and Default Configuration Getting to Know Your Wireless Router Unpacking Your New RouterActivity Description Hardware FeaturesFront Panel Back Panel DSLRouter Side Panel Positioning Your Wireless Router Router LabelInstalling Your Wireless Modem Router Getting to Know Your Wireless Router Getting to Know Your Wireless Router Installing Your Router Using Smart Wizard Using the Smart WizardInstalling Your Router Using the Smart Wizard Adsl Microfilters see Understanding Adsl Microfilters on Adsl Microfilter with Built-In Splitter Understanding Adsl MicrofiltersAdsl Microfilter Connecting Your Wireless Modem Router Two-line filter connection Verifying Your Connection Setting Up Your Router for Internet Access Page Read Troubleshooting on Configuring Your Wireless Network Specifying Wireless SettingsSetting Your Ssid and Wireless Security Manually Using Push N Connect WPS to Configure Your Wireless Network To set up basic wireless connectivity Configuring Your Wireless Network Configuring Your Wireless Network Troubleshooting Basic FunctioningLAN or Internet Port LEDs Not On Power LED Not OnPower LED is Red Troubleshooting the Web Configuration Interface Troubleshooting the ISP Connection Adsl linkObtaining an Internet IP Address Troubleshooting PPPoE or PPPoA Troubleshooting Internet BrowsingTroubleshooting a TCP/IP Network Using the Ping Utility Testing the LAN Path to Your RouterResetting to Factory Default Settings Restoring the Default Configuration and PasswordTesting the Path from Your Computer to a Remote Device General Specifications Default Configuration Feature Default Behavior Router LoginInternet Connection Local Network LANFeature Wireless Default Behavior NetgearTechnical Specifications and Default Configuration Related Documents Document LinkRelated Documents Registration and Certifications