ACTiSYS PP2-5600 user manual April 11, 2002 YLYang/Pre-release July 5, 2002 WWJ/Proofread

Page 1

PP2-5600 and PP2I-5600 User’s Manual

User’s Manual for:

PP2-5600 (Serial Modem)

PP2I-5600 (Infrared &Serial Modem)

Revision Issue Date

Engineer/Comments

1.0April 11, 2002 YLYang/Pre-release

1.1July 5, 2002 WWJ/Proofread

Copyright by 3JTech. Co., Ltd. All rights reserved.

2003/11 From 3JTech

Revision 1.0

Page 1 of 41

Image 1

Contents April 11, 2002 YLYang/Pre-release July 5, 2002 WWJ/Proofread Introduction Introduction II K Access Information Before You Start III. Hardware InstallationSystem Requirements Battery CompartmentFront View Rear ViewConnect the modem to a PC through the Serial Cable Setting Your ModemBy Serial Port Power-Down ModeGreen RedFor Palm Organiser IV. Software Installation GuideNetwork Set-up Infrared Modem User’s Manual For Windows CE/Pocket PC Pocket PC Modem settingChoose Advanced…. icon Step Pocket PC Connections settingMail settings Internet Explorer settingsChoose New Service Enter your Smtp mail serverPsion 5 Remote Dial-Up Connection Setup For Connecting Psion using Serial CableThis section uses Psion 5 as an example Hardware needed To set up your Fax information To set up an Email AccountTap on Initialization To Email or browse the web on Internet This section uses Psion 618C as an example For Connecting Psion using IrDA PortInfrared Modem User’s Manual Infrared Modem User’s Manual For Penbex Infrared Modem User’s Manual Infrared Modem User’s Manual For Sharp Infrared Modem User’s Manual Infrared Modem User’s Manual Infrared Modem User’s Manual For Windows98/Me/2000/XP Choose Virtual Infrared COM Port for IR Modem, Click Next ModemMrom Infrared Modem User’s Manual Remember the following before contacting Technical SupportMCU VI. SpecificationSoftware HardwareLimitation of Liability Standard Warranty Service Warranty ExclusiveDisclaimer Infrared Modem User’s Manual Appendix AWindows98 IR setupR220L/210L/200L Infrared Modem User’s Manual Infrared Modem User’s Manual Appendix BCountry code setting Appendix CAdvanced AT Commands For Debug