ACTiSYS PP2-5600 user manual Mrom

Page 30

Infrared Modem User’s Manual

7.Modem installed OK. Click OK.

8.Then set-up the baud rate. Click Properties to set-up the baud rate in Modem of Control Panel.

9.Choose “Com Port” for RS232 Modem,

and “Virtual Infrared COM Port” for IR Modem,

Choose Baud Rate (57,600) under ZyDAS ZD51_RS2

MROM.

Click OK to finish set-up.

2003/11 From 3JTech

Revision 1.0

Page 30 of 41

Image 30

Contents April 11, 2002 YLYang/Pre-release July 5, 2002 WWJ/Proofread Introduction Introduction II K Access Information III. Hardware Installation Before You StartFront View Battery CompartmentSystem Requirements Rear ViewSetting Your Modem Connect the modem to a PC through the Serial CableGreen Power-Down ModeBy Serial Port RedIV. Software Installation Guide For Palm OrganiserNetwork Set-up Infrared Modem User’s Manual Pocket PC Modem setting For Windows CE/Pocket PCChoose Advanced…. icon Pocket PC Connections setting StepChoose New Service Internet Explorer settingsMail settings Enter your Smtp mail serverFor Connecting Psion using Serial Cable Psion 5 Remote Dial-Up Connection SetupThis section uses Psion 5 as an example Hardware needed To set up an Email Account To set up your Fax informationTap on Initialization To Email or browse the web on Internet For Connecting Psion using IrDA Port This section uses Psion 618C as an exampleInfrared Modem User’s Manual Infrared Modem User’s Manual For Penbex Infrared Modem User’s Manual Infrared Modem User’s Manual For Sharp Infrared Modem User’s Manual Infrared Modem User’s Manual Infrared Modem User’s Manual For Windows98/Me/2000/XP Modem Choose Virtual Infrared COM Port for IR Modem, Click NextMrom Infrared Modem User’s Manual Technical Support Remember the following before contactingVI. Specification MCUHardware SoftwareStandard Warranty Service Warranty Exclusive Limitation of LiabilityDisclaimer Infrared Modem User’s Manual Appendix AWindows98 IR setupR220L/210L/200L Infrared Modem User’s Manual Infrared Modem User’s Manual Appendix BCountry code setting Appendix CAdvanced AT Commands For Debug