Abocom WAP2102 manual Upgrade Firmware, Dhcp Client Range Show Client, Other

Page 28

DHCP

DHCP Client Range

Show Client

Disable: Select to disable this Router to distribute IP Addresses (Disabled).

Server: Select to enable this Router to distribute IP Addresses (DHCP Server). And the following field will be activated for you to enter the starting IP Address.

The starting address of this local IP network address pool. The pool is a piece of continuous IP address segment. Keep the default value 192.168.1.1 should work for most cases.

Maximum: 253. Default value 253 should work for most cases.

Note: If “Continuous IP address poll starts” is set at 192.168.1.1 and the “Number of IP address in pool” is 253, the device will distribute IP addresses from 192.168.1.1 to 192.168.1.253 to all the computers in the network that request IP addresses from DHCP server (Router)

Click to show Active DHCP Client Table.

Refresh: Click this button to refresh the table.

Close: Click this button to close the window.

DNS Server

Apply Changes

Reset

Enter the Domain Name Service IP address.

After completing the settings on this page, click to save the settings.

Click to restore to default values.

Other

Upgrade Firmware

25

Image 28
Contents Wireless 802.11b/g Portable Router FCC Certifications FCC RF Radiation Exposure StatementCE Mark Warning CE Statement:Configuration PC ConfigurationAppendix a Troubleshooting Appendix B about Wireless Lans BSSIntroduction FeaturesHardware Connection LED Indicators Front Panel LED IndicatorsGW Mode AP ModeAbout the Operation Modes Client Mode Infrastructure Configuration LoginOther Modems e.g. Broadband Wireless Cable ModemsDSL Modems Common Connection TypesConfiguration via Web Operation ModeOperation Mode Access Point GatewayAP Mode AP Mode SettingsChannel Number Mode Alias Name BandSecurity Advanced Settings PSKBroadcast Ssid Access Control WDS Setting GW Mode ResetGateway Mode Settings Press Delete AllChannel Number Security Advanced Settings Click Setup button to enter the Wireless Advanced SettingsAccess Control Click Setup to enter the Wireless Access Control screenClick Setup to enter the WAN Port Configuration screen WAN PortVirtual Server DMZRemote Management URL Filter MAC Filter IP Filter Apply Changes Reset DdnsClient Mode Settings Client ModeAlias Name Page Site Survey Apply Changes Reset Address Wlan Configuration MAC Address SystemStatus System DataActive Clients LAN Interface Setup IP AddressSubnet Mask Upgrade Firmware DNS Server Apply Changes ResetDhcp Dhcp Client Range Show ClientReboot PasswordUpgrade Firmware Browse Upload Reset Factory DefaultDiagnostics Network Diagnostics DNS LookupLog System LogPC Configuration TCP/IP Settings OverviewOverview Windows ClientsChecking TCP/IP Settings Windows Using a fixed IP Address Use the following IP Address Using DhcpChecking TCP/IP Settings Windows XP Using Dhcp Accessing AOL Internet AccessFor Windows For Windows XPMacintosh Clients Linux ClientsOther Unix Systems Fixed IP AddressWireless Station Configuration Ssid EssidGeneral Problems TroubleshootingInternet Access Wireless Access About Wireless LANs Wireless LAN ConfigurationWEP Authentication ChannelsCE Standards Regulatory ApprovalsCE Marking Warning