Airlink101 AR685W user manual Telstra Big Pond, L2TP Gateway

Page 25

will fail even those settings of L2TP settings are correct. Please contact your Internet service provider if you don’t know what you should fill in these fields.

Now please go to L2TP settings section:

Parameter	Description
User Name	Please input user name assigned by your Internet service
	provider here.
Password	Please input the password assigned by your Internet service
	provider here.
L2TP Gateway	Please input the IP address of L2TP gateway
	assigned by your Internet service provider here.
MTU	Please input the MTU value of your network connection here. If
	you don’t know, you can use default value.
Connection Type	Please select the connection type of Internet connection you
	wish to use, please refer to last section for detailed descriptions.
Idle Time Out	Please input the idle time out of Internet connection you wish to
	use, and refer to last section for detailed descriptions.

When you finish with all settings, please click NEXT.

Telstra Big Pond

This setting only works when you are using Telstra Big Pond’s network service in Australia. You need to input:

26

Image 25

Contents Wireless N 300 Green Router Federal Communication Commission Interference Statement Table of Contents Troubleshooting Technical Support Package Contents FeaturesFront Panel LEDs Router InterfaceAntenna a Antenna B Using EZ Setup Wizard Installing the RouterPage Page Dynamic IP Cable Modem users PPPoE DSL users Page Congratulations! Your router configuration has been finished Connecting to the Router Wirelessly Page Using Web Configuration Utility Page Enable NTP Update Setup WizardCurrent Time Time Server Address Time ZoneDaylight Savings Host NameSecondary DNS Primary DNSService Name PasswordUser Name Connection TypePptp Connection ID Pptp GatewayL2TP Gateway Telstra Big PondServer IP Address Assign login server manuallyChannel Number BandAssociated Clients WPA2AES Page 1 WAN NetworkIP address 2 LANSubnet Mask 802.1d Spanning TreeLease Time Enable Static Dhcp LeasesDhcp Client Start IP Dhcp Client End IPPage NAT / Static Routing Delete All DeleteDdns Password/KeyDynamic DNS ProviderBasic Settings WirelessShow Active Clients Enable 802.1x Authentication Wireless SecurityEncryption See 3.2.2.1 to 3.2.2.3 for each encryption typeKey Length Default Tx KeyKey Format Encryption Key 1~4 WPA Pre-share KeyWPA Unicast Cipher Suite Radius Server PasswordPre-shared Key Format Pre-shared KeyMAC Control Enable MAC ControlComment ClearPage Advanced Settings Channel Width Tx PowerPreamble Type Broadcast Essid5 WPS Page Config Mode Enable WPSConfigure by Push Button Configure by Client PinCodeVirtual Server Port Forwarding Application & GamingYou can also click ‘Reset’ button to unselect all Special Applications Port Triggering Enable Special ApplicationsTCP/UDP Port to Open Popular ApplicationAdd in red box Parameter Description3 DMZ Enable DMZPublic IP Client PC IP addressButton ALG Settings 5 QoS Move Down Move UpRule Name BandwidthProtocol Traffic TypeEnable IP & Port Filtering Access Restrictions1 IP & Port Filtering Deny/AllowClient PC Description Client ServicePort Range Page MAC Filtering Enable MAC FilteringClient PC MAC Address Current MAC Filtering TableIf you want to delete a specific MAC address entry, check 3 URL/Keyword Filtering Enable URL FilteringURL/Keyword Current URL Blocking TableFirewall SecurityDoS Denial-of-Service Ping of Death IPsec pass through VPN Pass throughPptp pass through L2TP pass throughTime AdministrationNew Password Current PasswordConfirmed Password ManagementReset Reboot Remote Management Firmware Upgrade Backup Settings Configuration SettingsRestore Settings Restore to Factory DefaultSave 6 LogRefresh Statistics Internet Connection Status StatusLAN Status System Status Wlan Wireless LAN StatusTroubleshooting Technical Support