User’s Manual
23. Select OK.
Now you may test the PPP connection you have created if you wish. Otherwise you will be configuring Wireless ACE to startup your PPP connection automatically, later in the manual.
1.
2.You should see a "Connect To" dialog box. Verify the following settings:
User name and Password are blank.
Phone number = PPP (note that three P's appear here even though four were entered earlier. That is normal with Windows Millennium Edition.)
3.Select Connect. You should see a "Connecting to CDPD Modem PPP" dialog box.
Windows will establish a PPP session with the modem. When it succeeds, it will display the Dial Up Networking icon on the right of the Windows task bar (the two small computers)at the bottom of the screen.
Hovering over it (moving the mouse there but not clicking) causes
Windows to display reports on the number of bytes sent and received.
If you fail to establish a connection, review your settings starting with the Configuring the Modem section. A list of error messages and quick solutions are listed in the Troubleshooting section.
Proceed to the next section on Wireless ACE to setup your modem with it’s IP address and Side Preference so you can begin using it.
AirLink Communications, Inc. | August 9, 2001 | Page 13 |