Setting time and date [Time & Date]
•You can choose the order of the year, month, day by pressing the F2([M]/[D]/[Y] or [D]/[M]/[Y] or [Y]/[M]/[D])* button while setting them.
Example: October 14, 2012
10M 14D 2012Y (Initial setting)
14D 10M 2012Y
2012Y 10M 14D
*The display will vary depending on the status of the settings.
3Press the PLAY/OK button to complete the setting.
•The clock will start from the set date and time. Press the PLAY/OK button according to the time signal.
Notes
•If you press the STOP button during the setup operation, the settings are cancelled, and the recorder returns to the previous screen.
•You can set the time and date from your PC using DSS Player software (☞ P.53).
Changing the time and date
When the recorder’s POWER/HOLD switch is turned ON the [Time & Date] will be displayed for two seconds. If the time and date is not correct, set it using the procedure below.
1Press the + or − button in the [Device Menu] screen, then select [Time & Date].
•Refer to P.41 regarding each menu item settings.
Device Menu
Beep
Power Save
Time & Date
Battery
USB Settings
Reset Settings
BACKEXIT
2Press the PLAY/OK or 9button.
•The time and date screen appears. The hour indicator flashes, indicating the start of the time and date setup process. The following steps are the same as Step 1 through Step 3 of “Setting time and date [Time & Date]” (☞ P.20).
1
Setting time and date
3Press the F3(EXIT) or 0button to complete the setting.
EN
21