Canon DS-2 Inserting Batteries, Lightly press down on the arrow and slide, Battery cover open

Inserting Batteries

1	Lightly press down on the arrow and slide the
	1 battery cover open.

2 Insert two AAA alkaline batteries, observing the correct polarity.

3 Close the battery cover completely.

2

Replacing batteries

The battery indicator on the display changes as the batteries lose power.

➜ ➜ ➜

3	When	appears on the display, replace the batteries as
	soon as possible.
	When the batteries are too weak, the recorder shuts down
	and “BATTERY LOW” appears on the display. AAA alkaline
	batteries are recommended.
	An optional Ni-MH Rechargeable Battery from Olympus
	can be used for the recorder (☞ P.117).

....................................................................................................................................................

Notes

•Be sure to stop the recorder before replacing the batteries. Unloading the batteries while the recorder is in use may corrupt the file. If you are recording into a file and the batteries run out, you will lose your currently recorded file because the file header will not be able to close. It is crucial to change the batteries once you see only one Hash mark in the battery icon.

•Be sure to replace both batteries at the same time.

•Never mix old and new batteries, or batteries of different types and/or brands.

•If it takes longer than 1 minute to replace dead batteries, you may have to reset the time when you load fresh batteries (☞ P.14).

•Remove the batteries if you are not going to use the recorder for an extended period of time.

1

Inserting Batteries

11