Radio Shack PRO-82 manual Jctikpi 4GEJCTIGCDNG$CVVGTKGU, Installing Batteries

Preparation

R"9#40+0)"R"

Dispose of old batteries promptly and properly. Do not burn or bury them.

."%#76+10"."

If you do not plan to use the scanner with batteries for a month or more, remove the batteries. Batteries can leak chemicals that can destroy electronic parts.

±"016'"±"

Installing

Batteries

You must charge rechargeable batteries before you use them the first time. See “Charging Rechargeable Batteries”.

Charging

Rechargeable

Batteries

It takes about 15 hours to recharge fully discharged 1500mAh Ni-MH rechargeable batteries. You can operate the scanner while recharging the rechargeable batteries, but charging takes longer.

2.Pull the battery holder out of the battery compartment.

3.If you are using non- rechargeable batteries, place them into the black holder, as indicated by the polarity symbols (+ and –) marked on the holder. Or, if you are using rechargeable batteries, place them into the yellow holder, as indicated by the polarity symbols (+ and –) marked on the holder.

4.Place the battery holder into the battery compartment.

5.Replace the cover.

When 8 appears and the scanner beeps or the scanner stops operating properly, replace or recharge the batteries. Rý.#

If the scanner stops working prop- erly after connecting it to power, try resetting it. See “Resetting the Scanner” on Page 39. ±

%JCTIKPI"

4GEJCTIGCDNG"$CVVGTKGU"

Your scanner has a built-in charging circuit that lets you charge nickel-metal hydride (Ni- MH) or nickel cadmium (Ni-CD) rechargeable batteries (not supplied) while they are in the scanner. To charge rechargeable batteries, you need to use a 9V AC adapter (RadioShack Cat. No. 273-1767) or 10V DC adapter (Cat. No. 273-1830) and a size C Adaptaplug™ adapter (neither supplied). Both are available at your local RadioShack store.

.#±

8