Honeywell PRO-2200 manual Confidentiality

Page 8
Confidentiality

THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THIS PROVISION. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. NO REPRESEN- TATION OR WARRANTY OF THE DISTRIBUTOR SHALL EXTEND THE LIABILITY OR RESPONSIBILITY OF THE MANUFACTURER BEYOND THE TERMS OF THIS PROVISION. IN NO EVENT SHALL ENGINEERING SYSTEMS BE LIABLE FOR ANY RE-PROCUREMENT COSTS, LOSS OF PROFITS, LOSS OF USE, INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES TO ANY PERSON RESULTING FROM THE USE OF ENGINEERING SYSTEMS PRODUCTS.

Confidentiality

All software, drawings, diagrams, specifications, catalogs, literature, manuals and other materials furnished by Engineering Systems relating to the design, use and service of the Products shall remain confidential and shall constitute proprietary rights of Engineering Systems and Customer agrees to treat such informa- tion as confidential. Customer shall acquire no rights in the design of the Products or the related materials except to use such infor- mation solely for the purpose of and only during the time it sells the Products. Customer shall not copy the design of any of the Products or use or cause to be used any Product design or related materials for its own benefit or for the benefit of any other party. The covenants contained in this section shall remain effective throughout the term of this Agreement and thereafter unless specifically waived by Engineering Systems in writing.

The information in this document is subject to change without notice. ' 2001 Engineering Systems.

Image 8
Contents TD1145 rev0601 Part Number PRO22ENPRO-2200 Ethernet Board Installation Manual Page Contents Fire Safety and Liability Notice WARNINGS AND CAUTIONSPage Product Liability Mutual Indemnification UNPACKING PROCEDUREDISCLAIMER Limited Warranty Shipping InstructionsConfidentiality HARDWARE SETUP PROGRAMMING ETHERNET DEVICESPRO22EN Programming EQUIPMENT NEEDEDJumper PROGRAMMING THE ETHERNET CARD Note The 1 is port Click OK 6.Select Connect and Remote System8.Press Enter for Setup Mode 10.Your Choice? Enter 0 for server configurationType 1 Enter for Channel 1 configuration 18.Flow=02 Enter Flow Control Enabled19.Port Number=3001 Enter Winpak Pro uses port 20.Select Enter through the rest of the menusRemote IP Adr ---none ---,Port Connect Mode C0 Disconn ModePRO22EN Mounting Diagram BatteryLAN Card Connector Configuration Dip Switches S1Honeywell Security & Data Collection 2700 Blankenbaker Pkwy, Suite Louisville, KY
Related manuals
Manual 20 pages 9.1 Kb Manual 16 pages 41.44 Kb Manual 16 pages 15.65 Kb