Tecra 750 Series Disassembly Overview, (cont.)
ê
î
To install the Selectable Bay cover, follow the steps below.
1.To install the cover, first remove the Selectable Bay module then hold the cover by the two finger grips and push it into place until you hear the latches click.
2.To remove the cover, grasp the two finger grips and pull the cover out.
To disassemble the FDD, follow the steps below.
1.Remove six M2x6 silver screws.
2.Turn the FDD over and release two latches securing the upper plastic frame and lower plastic frame. Turn it back over and lift off the cover.
3.Lift off the upper shield cover, unseat the flexible cable connector from the lower plastic frame, then lift out the FDD.
4.Pull the flexible cable out of the FDD connector.
5.Remove four M2.5x2.8 black screws and remove the FDD from the bracket.
Toshiba TRR | Page 14 | 4/00, Tecra |