Tecra 750 Series Disassembly Overview, (cont.)
í
î
To assemble the HDD pack, follow the steps below.
1.Connect the flexible cable connector to the HDD.
2.Seat the HDD into the metal cover and secure four M3x4
3.Connect the connector cover to the flexible cable connector. When seating the connector cover, match the positioning pins to the holes on the flexible cable and metal cover.
CAUTION: Don’t hold the HDD by its flat sur- faces. It may damage the HDD.
4.Secure four M2.5x6 silver screws.
5.Mount the cover onto the HDD.
To install the HDD pack, follow the steps below.
1.Align the HDD pack with a marker on the computer and seat the HDD so that tabs on the HDD fit into notches on the computer.
2.Make sure the cover is pushed fully to the right and push the HDD back to ensure a firm connection.
3.Slide the cover to the left to lock the HDD into the slot.
4.Install the battery pack.
To remove the memory module(s), make sure the computer is in boot mode and follow the steps below.
CAUTION: Do not try to remove a memory module(s) with the computer turned on. You can damage the computer and the memory module(s).
1.Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.
2.Remove the battery pack, and HDD.
3.Remove two M2x3 silver screws securing the memory module socket cover and remove the cover.
4.Use a slender object to press two latches on either side of a memory module to the outside and the memory module will pop up.
NOTE: There could be two memory modules.
5.Grasp the memory module by the sides and pull it out.
CAUTION: Do not touch the connectors on the memory module(s) or on the computer. Debris on the connectors may cause memory access problems.
Toshiba TRR | Page 17 | 4/00, Tecra |