Tecra 750 Series Disassembly Overview, (cont.)
To remove the optional PC card, make sure the computer is in boot mode, then follow the steps below.
1.
2.
3.
4.
5.
6.
7.
To install a PC card, follow the steps below.
1. Open or remove the PC card slot cover.
2. Insert the PC card and press gently to ensure a firm connection.
3. Close the slot’s cover or replace the cover with an appropriate one.
4. Install the battery pack.
To remove the Selectable Bay module, follow the steps below.
1. Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.
2. Remove the battery pack.
3. Turn the computer upside down and slide the Selectable Bay lock so that a red mark appears. If cables are attached to the computer, be careful not to put pressure on the cables.
4. Lay the computer back down and pull out the release lever.
5. Push the release lever in firmly to pop the Selectable Bay module partially out of the bay.
6. Grasp the module and pull it out.
CAUTION: The Selectable Bay modules can become hot with use. Be careful when removing the module.
Install the Selectable Bay modules as described
below. | Verify the Selectable Bay lock is |
1. | |
| unlocked. |
2. | Insert the module in the computer and |
| press until it locks into place. |
3. | Fold the release lever into the closed |
| position. |
4. | Slide the Selectable Bay lock so that |
| the red mark is covered. |
5. | Install the battery pack. |
Toshiba TRR | Page 13 | 4/00, Tecra |