Tecra 750 Series Disassembly Overview, (cont.)
í
ê
To install a memory module(s), make sure the computer is in boot mode and follow the steps below.
CAUTION: Do not try to install a memory module(s) with the computer turned on. You can damage the computer and the module(s).
1.Position the connector on the bottom of the module over the corresponding connector on the computer. Place your fingers above the connector and press firmly but gently to ensure a solid connection. The module should be seated level.
CAUTION: Do not touch the connectors on the memory module(s) or on the computer. Debris on the connectors may cause memory access problems.
2.Lay the cover in place and secure it with two M2x3 silver screws.
3.Install the battery pack, and HDD.
The modem board is located under the palmrest. To open the palmrest, follow the steps below.
1.Turn off the power to the computer. Disconnect the AC adapter and all external cables connected to the computer.
2.Remove the battery pack, HDD pack, and optional memory module.
3.With the computer upside down, remove three M2x8 silver screws and two M2x22 silver screws.
4.Turn the computer right side up and open the display panel and the PC card cover.
5.Grasp the sides of the palmrest and pull it forward until tabs on either side clear holes on the top cover.
6.Carefully lift the palmrest to avoid damage. Three latches are located under the palmrest as shown below.
7.Remove four M2.5x6 screws in the modem slot and lift out the modem pack.
8.Disconnect the modem pack flexible connector from the system board.
î
Toshiba TRR | Page 18 | 4/00, Tecra |