Tecra 750 Series Disassembly Overview, (cont.)
To assemble the FDD, follow the steps below. 1. Seat the FDD in the bracket and
secure the bracket with four M2.5x2.8 black screws in the order numbered on the case. Tighten screws to a torque of less than 2.2 kgfcm.
2. Insert the flexible cable into the connector. Press gently to ensure a firm connection.
3. Seat the FDD in the lower plastic frame and set the upper shield cover in place.
4. Seat the flexible cable connector into the lower plastic frame.
5. Set the upper plastic frame in place, snap the two latches closed and secure six M2x6 silver screws.
To disassemble the
1. Remove four M2x3 screws and three M2x6 silver screws securing the frame to the
2. Slide the drive partially out of the drive frame.
3. Remove the connector cover and lift out the flexible cable.
CAUTION: Be very careful not to press on the top or bottom of the HDD. Pressure can destroy data or damage the drive.
To remove the HDD pack, follow the steps below. 1. Turn off the power to the computer.
Disconnect the AC adapter and all external cables connected to the computer.
2. Remove the battery pack.
3. Turn the computer upside down.
4. Slide the cover to the right and push the HDD pack forward until the back edge is aligned with a marker next to the HDD slot.
5. Lift up on the cover to remove the HDD pack.
Toshiba TRR | Page 15 | 4/00, Tecra |